Nissan Rogue (T33) 2021-Present Service Manual: B2601-42 Memory Failure for Firmware Over the Air
DTC Description
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms | DTC detected condition | |
|---|---|---|---|
| B2601-42 | Memory failure for firmware over the air | Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | Errors are detected in the memory for software automatic update function (OTA) | ||
| Diagnosis delay time | After downloading software automatic update function (OTA) data | ||
POSSIBLE CAUSE
8CH CAN gateway
FAIL-SAFE
Software automatic update function (OTA) fails, but system continue normal control.
Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Ignition switch ON and wait at least 2 seconds or more.
-
Select “Self Diagnostic Result� mode of “8ch CAN GATEWAY 2� using CONSULT.
-
Check DTC.
Is DTC B2601-42 detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Intermittent Incident
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
-
Ignition switch ON.
-
Perform DTC confirmation procedure again. Refer to Confirmation Procedure.
-
Check DTC.
Is DTC B2601-42 displayed?
YES>>Replace 8CH CAN gateway. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
C1f05-54 Front Camera Unit
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1F05
54
Front camera unit
(Front camera unit)
Diagnosis condition
When AEB system is ON
When driving the Nissan Ariya vehicle
Signal (te ...
Manual Air Conditioning. Precaution. Precautions
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG� and “SEAT BELT
PRE-TENSIONER�, used along with a front seat belt, helps to reduce the
risk or severity of injury to the driver and ...
With Idle Start/stop. System Description
Component Parts
Component Parts Location
No. Component Function
1.
Sub starter & generator
Refer to Sub starter & generator.
2.
Battery current sensor (with battery temperature sensor)
Refer to 12V Battery Current Sensor .
3.
ECM (Engine Control Module
The ...
