Nissan Rogue (T33) 2021-Present Service Manual: B261e-56 Pairing Error

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can Gateway :: Dtc Diagnosis [8ch Can Gateway (8ch Can Gateway)] / B261e-56 Pairing Error

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detected condition
B261E-56 Pairing error Diagnosis condition When ignition switch is ON.
Signal (terminal) —
Threshold HFM pairing not performed
Diagnosis delay time 10 seconds or more

POSSIBLE CAUSE

8CH CAN gateway

FAIL-SAFE

  • Voice recognition vehicle control (ROOF OPENING, ELECTRICAL SIDE DOOR OPENING AND CLOSING, REAR GATE OPENING, etc.) does not work.

  • Remote function (Remote Door lock/unlock, Remote horn & lights control, Remote Engine start, etc.) does not work.

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Ignition switch ON and wait at least 2 seconds or more.

  2. Select “Self Diagnostic Result” mode of “8ch CAN GATEWAY 2” using CONSULT.

  3. Check DTC.

Is DTC B261E-56 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Intermittent Incident

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

PERFORM PROGRAMMING OF 8CH CAN GATEWAY

Perform 8CH CAN gateway programming. Refer to Work Procedure.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

  1. Ignition switch ON.

  2. Perform DTC confirmation procedure again. Refer to Confirmation Procedure.

  3. Check DTC.

Is DTC B261E-56 displayed?

YES>>

Replace 8CH CAN gateway. Refer to Removal and Installation.

NO>>

INSPECTION END

    B2601-42 Memory Failure for Firmware Over the Air
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B2601-42 Memory failure for firmware over the air Diagnosis condition When ignition switc...
    U2340-87 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition U2340-87 CAN communication error (ECM) Diagnosis condition When ignition switch is ON. Si...

    Other materials:

    Power Supply and Ground Circuit
    Diagnosis Procedure CHECK FUSE Check that the following fuse is not blown: Signal name Fuse No. Ignition power supply 40 (10 A) Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit. NO>> GO TO 2. CHECK ADAS CONTROL UNIT 2 POWER SUPP ...

    P1148 Closed Loop Control
    DTC Description DTC DETECTION LOGICNOTE: DTC P1148 is displayed with DTC for A/F sensor 1. When the DTC is detected, perform the trouble diagnosis of DTC corresponding to A/F sensor 1. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1148 00 CLOS ...

    Driver Assistance System. Removal and Installation
    Front Camera Unit Without Propilot Assist 2.1 Exploded View Front camera unit bracket Front camera unit Front camera cover Metal clip Pawl     Removal and Installation REMOVALCAUTION: Do not remove front camera unit bracket and front camera cover ...