Nissan Rogue (T33) 2021-Present Service Manual: U2340-87 Can Comm Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can Gateway :: Dtc Diagnosis [8ch Can Gateway (8ch Can Gateway)] / U2340-87 Can Comm Circuit

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detected condition
U2340-87 CAN communication error (ECM) Diagnosis condition When ignition switch is ON.
Signal (terminal) CAN communication signal
Threshold Lost communication with ECM
Diagnosis delay time 4 seconds or more

POSSIBLE CAUSE

  • Harness or connector

    (CAN communication line)

  • 8CH CAN gateway

  • ECM malfunction

FAIL-SAFE

System continue normal control.

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Ignition switch ON and wait at least 4 seconds or more.

  2. Select “Self Diagnostic Result” mode of “8ch CAN GATEWAY 2” using CONSULT.

  3. Check DTC.

Is DTC U2340-87 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Intermittent Incident

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

  1. Ignition switch ON.

  2. Erase DTC.

  3. Perform DTC confirmation procedure again. Refer to Confirmation Procedure.

  4. Check DTC.

Is DTC “U2340-87” detected?

YES>>

Perform trouble diagnosis procedure for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

NO>>

INSPECTION END

    B261e-56 Pairing Error
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B261E-56 Pairing error Diagnosis condition When ignition switch is ON. Signal (terminal) ...
    U278c-88 Ethernet Circuit
    DTC Description DTC DETECTION LOGICWith type B meter DTC No. CONSULT screen terms DTC detected condition U278C-88 Ethernet circuit Diagnosis condition When ignition switch is ON...

    Other materials:

    Preparation
    Commercial Service Tools Tool Description Power tool Loosening screws Sealant or/and Lubricant Name Description Primer (3M K500, K520 or equivalent) Primer for attaching sonar sensor holder to bumper ...

    Fuel Pump
    Component Inspection CHECK FUEL PUMP Turn ignition switch OFF. Disconnect “fuel level sensor unit and fuel pump” harness connector. Check the resistance between “fuel level sensor unit and fuel pump” terminals as follows. Fuel level sensor unit and fuel pump Condition Res ...

    P2123 App Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2123 00 APP SEN 1/CIRC (Throttle/Pedal position sensor/switch D circuit high) Diagnosis condition Engine running at idle Signal (terminal) Accelerator ...