Nissan Rogue (T33) 2021-Present Service Manual: P1148 Closed Loop Control

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P1148 Closed Loop Control

DTC Description

DTC DETECTION LOGIC

NOTE:

DTC P1148 is displayed with DTC for A/F sensor 1.

When the DTC is detected, perform the trouble diagnosis of DTC corresponding to A/F sensor 1.

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P1148 00

CLOSED LOOP-B1

(Closed loop —b1) 		Diagnosis condition —
Signal (terminal) —
Threshold The closed loop control function does not operate even when Nissan Ariya vehicle is being driven in the specified condition
Diagnosis delay time —

POSSIBLE CAUSE

  • Harness or connectors (A/F sensor 1 circuit is open or shorted.)

  • A/F sensor 1

  • A/F sensor 1 heater

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

CHECK DTC PRIORITY

If DTC P1148 is displayed with another DTC for A/F sensor 1, perform the trouble diagnosis for the corresponding DTC.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Index.

NO>>

INSPECTION END

DTC Diagnosis Procedure

DTC P1148 is displayed with DTC for A/F sensor 1.

When the DTC is detected, perform the trouble diagnosis of DTC corresponding to A/F sensor 1.

Refer to DTC Index.

    P10ca Internal Control Module Fuel Injector
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P10CA 00 Cylinder3 injector A (Cylinder3 injector A) Diagnosis c...
    P1197 Out of Gas
    DTC Description This diagnosis result is detected when the fuel level of the fuel tank is extremely low and the engine does not run normally.DTC DETECTION LOGIC DTC CONSULT scre...

    Other materials:

    U0402 Can Communication
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0402 00 Invalid data (TCM) (Invalid Data Received From TCM) Diagnosis condition Ignition switch ON Signal (terminal) — Threshold When ECM is ...

    Réglages
    Informations de base Le mode de réglages permet à l’utilisateur de personnaliser les informations affichées sur l’écran d’informations du véhicule ainsi que plusieurs paramètres de fonctionnement du Nissan Rogue. Ces réglages offrent une adaptation fine du véhicule selon vos préfére ...

    Comment activer/désactiver la fonction de maintien de frein automatique
    Comment activer la fonction de maintien de frein automatique 1. Lorsque le contact d’allumage du Nissan Rogue est placé sur la position ON, appuyez sur la commande de maintien de frein automatique 1. Le témoin lumineux de la commande de maintien de frein automatique 2 s’allume pour co ...