Nissan Rogue (T33) 2021-Present Service Manual: B2600-56 Configuration Error

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can Gateway :: Dtc Diagnosis [8ch Can Gateway (8ch Can Gateway)] / B2600-56 Configuration Error

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detected condition
B2600-56 Configuration error Diagnosis condition When ignition switch is ON.
Signal (terminal) —
Threshold Monitoring mode is set.
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

8CH CAN gateway

FAIL-SAFE

—

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Ignition switch ON and wait at least 2 seconds or more.

  2. Select “Self Diagnostic Result” mode of “8ch CAN GATEWAY 2” using CONSULT.

  3. Check DTC.

Is DTC B2600-56 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Intermittent Incident

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

REMOVE AND INSTALL BATTERY

  1. Ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Connect the battery cable to the negative terminal.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

  1. Ignition switch ON.

  2. Perform DTC confirmation procedure again. Refer to Confirmation Procedure.

  3. Check DTC.

Is DTC B2600-56 displayed?

YES>>

Replace 8CH CAN gateway. Refer to Removal and Installation.

NO>>

INSPECTION END

    B2600-46 Configuration Error
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B2600-46 Configuration error Diagnosis condition When ignition switch is ON. Signal (term...
    B2601-42 Memory Failure for Firmware Over the Air
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B2601-42 Memory failure for firmware over the air Diagnosis condition When ignition switc...

    Other materials:

    Operation
    Head up Display Switch Name and Function Head Up Display SwitchNo.Switch nameDescription Head Up Display switch To turn the Head Up Display on, press the Head Up Display switch during ignition switch ON To turn the Head Up Display off, press the Head Up Display switch NOTE: ...

    P1098 Humidity Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1098 00 Humidity temperature sensor (Humidity temperature sensor Range/Performance) Diagnosis condition Engine cold start Signal (terminal) － T ...

    Type B. Precaution. Precautions
    Precautions Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and ...