Nissan Rogue (T33) 2021-Present Service Manual: B2600-46 Configuration Error

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can Gateway :: Dtc Diagnosis [8ch Can Gateway (8ch Can Gateway)] / B2600-46 Configuration Error

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detected condition
B2600-46 Configuration error Diagnosis condition When ignition switch is ON.
Signal (terminal) —
Threshold Errors are detected in the programming data stored in the 8CH CAN gateway
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

8CH CAN gateway

FAIL-SAFE

  • The 8CH CAN gateway will stop transmitting and receiving the following:

  • CAN communication signals between each CAN communication circuit

  • Ethernet communication signals between each ethernet communication circuit

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Ignition switch ON and wait at least 2 seconds or more.

  2. Select “Self Diagnostic Result” mode of “8ch CAN GATEWAY 2” using CONSULT.

  3. Check DTC.

Is DTC B2600-46 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Intermittent Incident

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

PERFORM PROGRAMMING OF 8CH CAN GATEWAY

Perform 8CH CAN gateway programming. Refer to Work Procedure.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

  1. Ignition switch ON.

  2. Perform DTC confirmation procedure again. Refer to Confirmation Procedure.

  3. Check DTC.

Is DTC B2600-46 displayed?

YES>>

Replace 8CH CAN gateway. Refer to Removal and Installation.

NO>>

INSPECTION END

    B2600-42 Configuration Error
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B2600-42 Configuration error Diagnosis condition After the ignition switch OFF, wait for ...
    B2600-56 Configuration Error
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B2600-56 Configuration error Diagnosis condition When ignition switch is ON. Signal (term...

    Other materials:

    P044c Egr Volume Control Valve Position Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P044C 00 EGR SENSOR C (EGR sensor C circuit low) Diagnosis condition Ignition switch ON Signal (terminal) EGR volume control valve signal Threshol ...

    System Description. Component Parts. Moonroof System
    Moonroof System Component Description No. Component Function 1. Moonroof switch assembly Refer to Moonroof Switch Assembly. 2. Moonroof motor assembly Refer to Moonroof Motor Assembly. 3. Front door lock assembly RH (door switch) Detects door open/close condition ...

    Fuel Pump
    Component Inspection CHECK FUEL PUMP Turn ignition switch OFF. Disconnect “fuel level sensor unit and fuel pump” harness connector. Check the resistance between “fuel level sensor unit and fuel pump” terminals as follows. Fuel level sensor unit and fuel pump Condition Res ...