Nissan Rogue (T33) 2021-Present Service Manual: B2600-42 Configuration Error

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can Gateway :: Dtc Diagnosis [8ch Can Gateway (8ch Can Gateway)] / B2600-42 Configuration Error

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detected condition
B2600-42 Configuration error Diagnosis condition

  • After the ignition switch OFF, wait for 1 minutes or more

  • When ignition switch is ON.
Signal (terminal) —
Threshold Errors are detected in the data stored in the 8CH CAN gateway (except programming data)
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

8CH CAN gateway

FAIL-SAFE

The 8CH CAN gateway will stop transmitting and receiving the following:

  • CAN communication signals between each CAN communication circuit

  • Ethernet communication signals between each ethernet communication circuit

Confirmation Procedure

PRECONDITIONING

After the ignition switch OFF, open the driver's side door and wait for 2 minutes or more.

CAUTION:

Since the auto ACC function causes the accessory power to be turned ON, do not perform any Nissan Ariya vehicle operation including locking the doors or opening and closing of the doors during the standby state. Refer to System Description.

YES>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Ignition switch ON and wait at least 2 seconds or more.

  2. Select “Self Diagnostic Result” mode of “8ch CAN GATEWAY 2” using CONSULT.

  3. Check DTC.

Is DTC B2600-42 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Intermittent Incident

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

  1. Ignition switch ON.

  2. Erase DTC.

  3. Perform DTC confirmation procedure again. Refer to Confirmation Procedure.

  4. Check DTC.

Is DTC B2600-42 displayed?

YES>>

Replace 8CH CAN gateway. Refer to Removal and Installation.

NO>>

INSPECTION END

    Can Gateway. Dtc Diagnosis [8ch Can Gateway (8ch Can Gateway)]
    B2600-46 Configuration Error
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B2600-46 Configuration error Diagnosis condition When ignition switch is ON. Signal (term...

    Other materials:

    Système d'alerte vigilance conducteur intelligent
    Informations de base AVERTISSEMENT Le non-respect des instructions et avertissements relatifs à l’utilisation correcte du système d’alerte vigilance conducteur intelligent du Nissan Rogue peut entraîner des blessures graves, voire mortelles. Le système d’alerte vigilance conducteur ...

    Système d'avertisseur sonore du Nissan Rogue
    Pour actionner l'avertisseur sonore de votre Nissan Rogue, exercez une pression ferme sur la zone centrale rembourrée du volant. Ce dispositif est conçu pour émettre un signal clair afin d'avertir les autres usagers de la route en cas de nécessité. AVERTISSEMENT DE SÉCURITÉ Il est s ...

    Dtc/circuit Diagnosis. Front Wiper Motor Lo Circuit
    Component Function Check CHECK FRONT WIPER LO OPERATION CONSULT Select “Front wiper” in “Active test” mode of “BCM [WIPER]”. With operating the test item, check front wiper operation. Low : Front wiper (LO) operation Off : Stop the front wiper Is the in ...