Nissan Rogue (T33) 2021-Present Service Manual: U1327-54 Mac Key
DTC Description
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms | DTC detection condition | ||
|---|---|---|---|---|
| U1327 | 54 | MAC key update | Diagnosis condition | — |
| Signal (terminal) | — | |||
| Threshold | MAC key is not written after chassis control module replacement. | |||
| Diagnosis delay time | — | |||
POSSIBLE CAUSE
-
Writing of MAC key has not been executed
-
Chassis control module
FAIL-SAFE
The following functions are suspended.*
-
Intelligent trace control function
-
Active ride control function
-
Automatic brake hold function
-
Drive mode selector function
*: Depends on the DTC detection status
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Ignition switch ON.
-
Perform “MAC Diagnosis” of “CHASSIS CONTROL” using CONSULT.
Is DTC “U1327-54” detected as the current malfunction?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
PERFORM MAC KEY WRITING
With CONSULT
-
Perform “MAC key writing”. Refer to Description.
-
Perform “MAC Diagnosis” of “CHASSIS CONTROL” using CONSULT.
Is DTC “U1327-54” detected as the current malfunction?
YES>>GO TO 2.
NO>>INSPECTION END
PERFORM MAC KEY WRITING AGAIN (SECOND TIMES)
With CONSULT
-
Restart CONSULT.
-
Perform “MAC Key writing” again. Refer to Description.
-
Perform “MAC Diagnosis” of “CHASSIS CONTROL” using CONSULT.
Is DTC “U1327-54” detected as the current malfunction?
YES>>GO TO 3.
NO>>INSPECTION END
PERFORM MAC KEY WRITING AGAIN (THIRD TIMES)
With CONSULT
-
Restart CONSULT.
-
Perform “MAC Key writing” again. Refer to Description.
-
Perform “MAC Diagnosis” of “CHASSIS CONTROL” using CONSULT.
Is DTC “U1327-54” detected as the current malfunction?
YES>>Replace the chassis control module. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
Symptom Diagnosis. Automatic Back Door Functions Do Not Cancel
Diagnosis Procedure
CHECK “POWER BACK DOOR SETTING” IN COMBINATION METER
Check “Power back door setting” is in the OFF.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Set “Power back door setting” to “OFF”.
REPLACE AUTOMATIC BACK DOOR CONTROL UNIT
Rep ...
Témoins d'avertissement et témoins lumineux
Témoins d'avertissement/lumineux
(rouge)
Témoins d'avertissement/lumineux
(jaune)
Témoins d'avertissement/lumineux
(autres)
Vérification des témoins
Toutes portières fermées, serrez le frein de stationnement, attachez les ceintures de sécurité et positionnez le cont ...
Engine oil
Checking engine oil level
Park the vehicle on a level area and apply the parking brake.
Warm up the engine to operating temperature.
Shut the engine off and wait at least 10 minutes.
Remove the dipstick, wipe it clean, then fully reinsert it.
Remove the dipstick again and check the oil le ...
