Nissan Rogue (T33) 2021-Present Service Manual: U1327-52 Mac Key

Nissan Rogue (T33) 2021-Present Service Manual / Cruise Control & Driver Assistance :: Driver Assistance System / Chassis Control :: Dtc/circuit Diagnosis / U1327-52 Mac Key

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detection condition
U1327 52 MAC key update Diagnosis condition —
Signal (terminal) —
Threshold MAC key writing is incomplete.
Diagnosis delay time —

POSSIBLE CAUSE

  • Network communication error between CONSULT and chassis control module

  • Chassis control module used in other Nissan Ariya vehicles is installed in the vehicle

  • Chassis control module

FAIL-SAFE

The following functions are suspended.*

  • Intelligent trace control function

  • Active ride control function

  • Automatic brake hold function

  • Drive mode selector function

*: Depends on the DTC detection status

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC “U1327-52” is displayed with DTC “U1327-54”, first perform the trouble diagnosis for DTC “U1327-54”.

Is DTC “U1327-54” detected?

YES>>

Refer to DTC Description.

NO>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Ignition switch ON.

  2. Perform “MAC key writing”. Refer to Description.

  3. Perform “MAC Diagnosis” of “CHASSIS CONTROL” using CONSULT.

Is DTC “U1327-52” detected as the current malfunction?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK DTC PRIORITY

If DTC “U1327-52” is displayed with DTC “U1327-54”, first perform the trouble diagnosis for DTC “U1327-54”.

Is DTC “U1327-54” detected?

YES>>

Refer to DTC Description.

NO>>

GO TO 2.

PERFORM MAC KEY WRITING

With CONSULT

  1. Perform “MAC key writing”. Refer to DTC Description.

  2. Perform “MAC Diagnosis” of “CHASSIS CONTROL” using CONSULT.

Is DTC “U1327-52” detected as the current malfunction?

YES>>

GO TO 3.

NO>>

INSPECTION END

REPLACE CHASSIS CONTROL MODULE

Replace the chassis control module. Refer to Removal and Installation.

>>

INSPECTION END

    U0076-00 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition U0076 00 Control module communication Bus D Off Diagnosis condition When ignition switch...
    U1327-54 Mac Key
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition U1327 54 MAC key update Diagnosis condition — Signal (terminal) — Threshold MAC key ...

    Other materials:

    Av Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). AV control unit 8CH CAN gateway ...

    Symptom Diagnosis. Normal Operating Condition
    Description The following symptoms are normal operations, and they do not indicate a malfunction. Symptom Cause Action to take Reference Entry/exit assist function do not operate. Entry/exit assist function is disabled. Change the settings. Description Entry assist function does ...

    Side Radar (rear Right) (side Radar Rear Rh)
    C1e80-44 Control Unit DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1E80–44 Control unit (Control unit) Diagnosis condition When ignition switch is ON. Signal (terminal) - Threshold If sid ...