Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2c41-04 Power Window Motor Fl

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Power Window Control System / Dtc/circuit Diagnosis :: B2c41-04 Power Window Motor Fl

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
B2C41-04

Power window motor FL

[Front power window motor (driver side)] 		Diagnosis condition When ignition switch ON or power window timer operates.
Signal (terminal) —
Threshold CPU in front power window motor (driver side) detects internal malfunction.
Diagnosis delay time 10 seconds

POSSIBLE CAUSE

Front power window motor (driver side)

FAIL SAFE

Front power window motor (driver side) operation is stop or inching.

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Keep pulling the power window switch AUTO-UP for 5 seconds or more.

  3. Keep pressing the power window switch AUTO-DOWN for 5 seconds or more.

  4. Select “Self Diagnostic Result” mode of “BCM”.

  5. Check DTC.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

REPLACE FRONT POWER WINDOW MOTOR (DRIVER SIDE)

  1. Replace front power window motor (driver side). Refer to Disassembly and Assembly.

  2. Perform DTC confirmation procedure. Refer to DTC Description.

Is DTC detected?

YES>>

Ceck intermittent incident. Refer to Intermittent Incident.

NO>>

Inspection End.

    Dtc/circuit Diagnosis. B2c40-95 Power Window Main Switch
    DTC Description NOTE: When the ignition switch is placed ON, the DTC may be detected. If it has been detected due to previous error/operation, erase the history once and check i...
    Dtc/circuit Diagnosis. Power Supply and Ground Circuit
    Power Window Main Switch Diagnosis Procedure CHECK FUSE Ignition switch OFF, and then wait for 3 minutes with driver door open. NOTE: Even after ignition switch is OFF, power is...

    Other materials:

    Removal and Installation. 12v Battery Current Sensor
    Exploded View : 12V battery current sensor : Harness connector : N·m (kg-m, in-lb) Removal and Installation REMOVALDisconnect the 12V battery current sensor connector . Remove negative cable mounting nut , and then remove the negative cable . Loosen 12V battery cu ...

    Engine. Starting System
    Precaution :: Precautions Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to t ...

    Intelligent Key battery replacement
    WARNING Do not ingest the battery — Chemical Burn Hazard. This product contains a coin/button cell battery. If swallowed, it can cause severe internal burns within hours and may lead to death. Keep both new and used batteries away from children. If the battery compartment of your Nissan R ...