Nissan Rogue (T33) 2021-Present Service Manual: Configuration

Nissan Rogue (T33) 2021-Present Service Manual / Brakes :: Brake Control System / With Vdc :: Basic Inspection / Configuration

Description

Vehicle specification needs to be written with CONSULT because it is not written after replacing the ABS actuator and electric unit (control unit).

The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the Nissan Ariya vehicle specification to the ABS actuator and electric unit (control unit).

Refer to Work Procedure.

NOTE:

For details the network connection and operation, refer to “CONSULT Operation Manual”.

The configuration no need to “save” configuration data from the ABS actuator and electric unit (control unit). The configuration data is always generated freshly at the server and then downloaded to the CONSULT.

CAUTION:

  • Complete the procedure of “Configuration” in order.

  • If incorrect “Configuration”, incidents might occur.

  • Never perform “Configuration” except for new ABS actuator and electric unit (control unit).

Work Procedure

WRITING VEHICLE SPECIFICATION

CONSULT

Perform writing Nissan Ariya vehicle specification to ABS actuator and electric unit (control unit) following "Automatic Configuration" procedure of "Configuration" according to CONSULT Operation Manual.

NOTE:

  • Log in the network according to CONSULT guidance.

  • For details the network connection and operation, refer to “CONSULT Operation Manual”.

>>

WORK END

    Additional Service When Replacing Abs Actuator and Electric Unit (control Unit)
    Work Procedure DescriptionWhen replacing the ABS actuator and electric unit (control unit), the procedures of BEFORE REPLACEMENT and AFTER REPLACEMENT must be performed.BEFORE R...
    Adjustment of Steering Angle Sensor Neutral Position
    Description Always adjust the neutral position of steering angle sensor before driving when the following operation is performed. Refer to Work Procedure.×: Required —: Not r...

    Other materials:

    Symptom Diagnosis. Automatic Back Door Functions Do Not Cancel
    Diagnosis Procedure CHECK “POWER BACK DOOR SETTING” IN COMBINATION METER Check “Power back door setting” is in the OFF. Is the inspection result normal? YES>> GO TO 2. NO>> Set “Power back door setting” to “OFF”. REPLACE AUTOMATIC BACK DOOR CONTROL UNIT Rep ...

    Component Parts
    Automatic Emergency Braking System - With Propilot Assist 2.1 Component Parts Location No. Component Function 1. ADAS (Advanced Driver Assistance System) Control Unit 2 Refer to Component Parts Location for detailed component location. 2. Distance Sensor Refer to Component ...

    Power Supply and Ground Circuit
    Combination Meter Diagnosis Procedure CHECK FUSE Check that the following fuses are not blown: Unit Location Fuse No. Capacity Combination meter Fuse block (J/B) 29 5A 6 5A Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circu ...