Nissan Rogue (T33) 2021-Present Service Manual: Change of System Mode

Nissan Rogue (T33) 2021-Present Service Manual / Brakes :: Brake Control System / With Vdc :: Basic Inspection / Change of System Mode

Description

CAUTION:

When the following operations are performed, always use CONSULT, for performing “SYSTEM MODE CHANGE” of “WORK SUPPORT”. Refer to Work Procedure.

×: Required —: not required

Procedure SYSTEM MODE CHANGE
Removing/installing ABS actuator and electric unit (control unit) —
Replacing ABS actuator and electric unit (control unit) ×
Removing/installing rear brake pad (When not pressing piston of rear brake caliper assembly) —
Replacing rear brake caliper assembly —
Removing/installing parking brake switch —
Replacing parking brake switch —

Work Procedure

CAUTION:

When performing the following operations, always use CONSULT. (It cannot be performed by any means other than CONSULT.)

  • Replacing ABS actuator and electric unit (control unit)

CHANGE OF SYSTEM MODE

CONSULT

  1. Select “ABS”, “Work support”, and “System mode change” according to this order.

    CAUTION:

    Never operate the parking brake switch.

  2. Touch “OFF”.

>>

GO TO 2.

PERFORM THE SELF-DIAGNOSIS

CONSULT

  1. Pull parking brake switch to activate electric parking brake.

  2. Push parking brake switch to release electric parking brake.

  3. Perform self-diagnosis for “ABS”.

Is malfunction detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

Inspection End

    Removal/replacement of Rear Brake Pad or Rear Brake Caliper
    Description CAUTION: When performing the following operations, always use CONSULT, for performing “START BRAKE PAD REPLACEMENT”, “FINISH BRAKE PAD REPLACEMENT”, “INITI...
    With Vdc. Dtc/circuit Diagnosis

    Other materials:

    P04fa Egr Temperature
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P04FA 00 EGR A control (EGR "A" Control temperature Too High) Diagnosis condition — Signal (terminal) — Threshold ECM detects that a signal ...

    Removal and Installation. Glass Lid Guide
    Exploded View Refer to Exploded View. Removal and Installation REMOVALRemove drain assembly. Refer to Removal and Installation. Remove glass lid guide.INSTALLATIONNote the following items, and then install in the reverse order of removal.CAUTION: When installation, move glass lid guide most ...

    P0500 Vss
    DTC Description DESCRIPTIONECM receives vehicle speed signals from two different paths via CAN communication line: One is from the ABS actuator and electric unit (control unit) via the combination unit and the other is from TCM.DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagno ...