Nissan Rogue (T33) 2021-Present Service Manual: C1219-11 Awd Control Unit

Nissan Rogue (T33) 2021-Present Service Manual / Transmission & Driveline :: Driveline / Transfer: Ty92a :: Dtc/circuit Diagnosis / C1219-11 Awd Control Unit

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detecting condition
C1219-11

CONTROLLER TEMPE SENSOR

(Controller temperature sensor) 		Diagnosis condition Ignition switch: ON
Signal —
Threshold

When temperature sensor in AWD control unit is shorted.

(Temperature sensor voltage < threshold)
Diagnosis delay time 100 ms or more

POSSIBLE CAUSE

Internal malfunction of AWD control unit

(Malfunction of the temperature sensor in the AWD control unit due to short circuit)

FAIL-SAFE

Although AWD control is canceled, the vehicle can drive at 2WD condition.

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

DTC REPRODUCTION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Drive at 10 km/h (6 MPH) or more for approximately 5 minutes in urban areas.

  3. Stop the Nissan Ariya vehicle.

  4. Perform "Self diagnosis result" mode of “AWD/4WD”.

Is DTC “C1219-11” detected?

YES>>

Proceed to diagnosis procedure. Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

PERFORM SELF DIAGNOSIS

CONSULT

  1. Erase "Self diagnosis result" mode of “AWD/4WD”.

  2. Ignition switch OFF.

  3. Wait for 10 seconds or more.

  4. Ignition switch ON.

  5. Wait for 15 seconds or more.

  6. Perform "Self diagnosis result" mode of “AWD/4WD”.

Is DTC “C1219-11” detected?

YES>>

Replace actuator assembly due to the malfunction of the AWD control unit. Refer to Disassembly and Assembly.

NO>>

Inspection End.

    C1218-19 Electro-Hydraulic Coupling
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1218-19 PUMP (Pump) Diagnosis condition Ignition switch: ON Nis...
    C1219-13 Awd Control Unit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1219-13 CONTROLLER TEMPE SENSOR (Controller temperature sensor)...

    Other materials:

    P02ee Fuel Injector
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P02EE 00 Cylinder 1 injector (Cylinder 1 Injector Circuit Range/Performance) Diagnosis condition Injector compensation control is operating Signal — ...

    Information Display (combination Meter)
    Door Open Warning DESIGN/PURPOSEInformation display warns the driver that each door is open or is not fully closed. Symbol Message – SYNCHRONIZATION WITH MASTER WARNING LAMPSynchronization is applied.Refer to Master Warning Lamp.SYSTEM DIAGRAMSIGNAL PATH BCM transmits door switch ...

    C106f-54 Steering Angle Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C106F 54 Steering angle sensor (Steering angle sensor) Diagnosis condition When ignition switch is ON. When the power supply voltage is normal. ...