Nissan Rogue (T33) 2021-Present Service Manual: C1218-19 Electro-Hydraulic Coupling

Nissan Rogue (T33) 2021-Present Service Manual / Transmission & Driveline :: Driveline / Transfer: Ty92a :: Dtc/circuit Diagnosis / C1218-19 Electro-Hydraulic Coupling

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detecting condition
C1218-19

PUMP

(Pump) 		Diagnosis condition

  • Ignition switch: ON

  • Nissan Ariya Vehicle running
Signal —
Threshold When the current required to operate the hydraulic piston for the required pressure/torque is too high.
Diagnosis delay time 10 seconds or more

POSSIBLE CAUSE

Hydraulic piston defect (stuck axle etc) in electro-hydraulic coupling

FAIL-SAFE

Although AWD control is canceled, the vehicle can drive at 2WD condition.

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

DTC REPRODUCTION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Drive at 10 km/h (6 MPH) or more for approximately 5 minutes in urban areas.

  3. Stop the Nissan Ariya vehicle.

  4. Perform "Self diagnosis result" mode of “AWD/4WD”.

Is DTC “C1218-19” detected?

YES>>

Proceed to diagnosis procedure. Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

PERFORM SELF DIAGNOSIS

CONSULT

  1. Erase "Self diagnosis result" mode of “AWD/4WD”.

  2. Ignition switch OFF.

  3. Wait for 10 seconds or more.

  4. Ignition switch ON.

  5. Wait for 15 seconds or more.

  6. Perform "Self diagnosis result" mode of “AWD/4WD”.

Is DTC “C1218-19” detected?

YES>>

Replace electro-hydraulic coupling assembly. Refer to Removal and Installation.

NO>>

Inspection End.

    C1218-18 Electro-Hydraulic Coupling
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1218-18 PUMP (Pump) Diagnosis condition Ignition switch: ON Nis...
    C1219-11 Awd Control Unit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1219-11 CONTROLLER TEMPE SENSOR (Controller temperature sensor)...

    Other materials:

    C106f-54 Steering Angle Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C106F 54 Steering angle sensor (Steering angle sensor) Diagnosis condition When ignition switch is ON. When the power supply voltage is normal. ...

    Dtc/circuit Diagnosis. B100e-1a Knee Air Bag Module Rh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B100E-1A Knee air bag module RH (Knee air bag module right hand) Diagnosis condition When ignition switch is ON. Signal (terminal) Knee air bag module RH si ...

    Dtc/circuit Diagnosis. B0028-09 Side A/b Module Rh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B0028-09 SIDE A/B MODULE RH (Right Side Airbag Deployment Control) Diagnosis condition When ignition switch is ON. Signal (terminal) Front side air bag modu ...