Nissan Rogue (T33) 2021-Present Service Manual: C10b5-76 Parking Brake Assembly Check
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |||
|---|---|---|---|---|---|
| C10B5 | 76 |
Parking brake assembly check (Parking brake assembly check) |
Diagnosis condition | System is high temperature status. | |
| Signal (terminal) | — | ||||
| Threshold | When an internal malfunctioning in the ABS actuator and electric unit (control unit) (Maintenance mode). | ||||
| Diagnosis delay time | 30 seconds or more | ||||
POSSIBLE CAUSE
NOTE:
Confirm if DTC is PAST or CRNT. If DTC is CRNT, proceed with Diagnosis Procedure. If DTC is PAST, clear DTC. Do not replace the ABS actuator and electric unit (control unit) for a PAST DTC.
| PAST DTC | CRNT DTC |
|---|---|
|
|
FAIL-SAFE
The following functions are suspended.
Electric parking brake function
DTC CONFIRMATION PROCEDURE
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF (Auto ACC function OFF) before conducting the next test.
>>
GO TO 2.
CHECK DTC DETECTION
CONSULT
-
Ignition switch OFF (Auto ACC function OFF) to ON.
-
Push the parking brake switch.
CAUTION:
-
Set the electric shift selector in the P position.
-
Depress the brake pedal.
-
-
Pull the parking brake switch.
-
Perform self-diagnosis for “ABS”.
Is DTC “C10B5-76” detected?
YES-1>>“CRNT” is displayed: Refer to Diagnosis Procedure.
YES-2>>“PAST” is displayed: Inspection End (Erase the memory of self-diagnosis results.)
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
PROGRAMING OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
Perform programing of ABS actuator and electric unit (control unit). Refer to Work Procedure.
>>
GO TO 2.
PERFORM SELF-DIAGNOSIS
CONSULT
-
Ignition switch ON.
CAUTION:
Be sure wait of 10 seconds after ignition switch ON.
-
Perform self-diagnosis for “ABS”.
Is DTC “C10B5-76” detected?
YES-1>>"CRNT" is displayed: Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.
YES-2>>“PAST” is displayed: Inspection End (Erase the memory of self-diagnosis results.)
NO>>Inspection End
Other materials:
System maintenance
To ensure proper operation of the driver monitoring system on the Nissan Rogue, keep the camera and surrounding area clean. Use a soft, damp cloth—such as one designed for lens cleaning—wrung out thoroughly, and gently wipe the surface to remove dust or dirt.
License information (ProPILOT Ass ...
C0513 Wheel Speed Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
C0513
00
Right rear wheel speed sensor
(Right Rear Wheel Speed Sensor Range/Performance)
Diagnosis condition
Ignition switch ON
Battery voltage: 11 V ...
P0532 A/c Refrigerant Pressure Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0532
00
REFRIGERANT PRESS SENSOR A
(A/C refrigerant pressure sensor A circuit low)
Diagnosis condition
—
Signal (terminal)
Refrigerant pressure sens ...
