Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: Additional Service When Replacing Automatic Back Door Control Unit

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Door & Lock / Basic Inspection :: Additional Service When Replacing Automatic Back Door Control Unit

Description

When replacing automatic back door control unit necessary to perform initial setting to operate automatic back door system normally. Refer to Work Procedure.

Work Procedure

STEP 1

CONSULT

  1. Select “Reset auto back door status” in “Work supports” mode of "AUTOMATIC BACK DOOR".

  2. Touch “Start” to erase automatic back door position information.

>>

GO TO 2.

STEP 2

Fully close the back door manually.

>>

GO TO 3.

STEP 3

Operate back door opener switch and perform automatic back door open operation.

>>

GO TO 4.

STEP 4

  1. The back door fully opens.

  2. Check that automatic back door warning buzzer sounds normally.

Does automatic back door warning buzzer sound normally?

YES>>

GO TO 5.

NO>>

GO TO 2.

STEP 5

Fully close the back door.

>>

Work End.

    Basic Inspection. Additional Service When Replacing Intelligent Key Unit
    Description CAUTION: When replacing the Intelligent Key unit, always replace it with a new one. The functions controlled by the Intelligent Key unit does not operate properly in...
    Basic Inspection. Configration (intelligent Key Unit)
    Description Vehicle specification needs to be written with CONSULT because it is not written after replacing the Intelligent Key unit.The configuration requires network connecti...

    Other materials:

    Comment activer/désactiver la fonction de maintien de frein automatique
    Comment activer la fonction de maintien de frein automatique 1. Lorsque le contact d’allumage du Nissan Rogue est placé sur la position ON, appuyez sur la commande de maintien de frein automatique 1. Le témoin lumineux de la commande de maintien de frein automatique 2 s’allume pour co ...

    Rear Final Drive: R145. Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
    Noise, Vibration and Harshness (nvh) Troubleshooting NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference Noise Vibration Gear tooth rough × – Inspectio ...

    P026b Injection Timing
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P026B 00 Injection timing Diagnosis condition — Signal — Threshold ECM does not control fuel injection timing properly when engine is running ...