Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: Configration (intelligent Key Unit)

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Door & Lock / Basic Inspection :: Configration (intelligent Key Unit)

Description

Vehicle specification needs to be written with CONSULT because it is not written after replacing the Intelligent Key unit.

The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the Nissan Ariya vehicle specification to the Intelligent Key unit.

Refer to Work Procedure.

NOTE:

For details the network connection and operation, refer to “CONSULT Operation Manual”.

The configuration no need to “save” configuration data from the Intelligent Key unit. The configuration data is always generated freshly at the server and then downloaded to the CONSULT.

CAUTION:

  • Complete the procedure of “Configuration” in order.

  • If incorrect “Configuration”, incidents might occur.

  • Never perform “Configuration” except for new Intelligent Key unit.

Work Procedure

WRITING VEHICLE SPECIFICATION

CONSULT

Perform writing Nissan Ariya vehicle specification to Intelligent Key unit following "Automatic Configuration" procedure of "Configuration" according to CONSULT Operation Manual.

NOTE:

  • Log in the network according to CONSULT guidance.

  • For details the network connection and operation, refer to “CONSULT Operation Manual”.

>>

Work End.

    Basic Inspection. Additional Service When Replacing Automatic Back Door Control Unit
    Description When replacing automatic back door control unit necessary to perform initial setting to operate automatic back door system normally. Refer to Work Procedure. Work Pr...
    Basic Inspection. Calibration of Automatic Back Door Position Information
    Description When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system. R...

    Other materials:

    Dlc Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). Data link connector 8CH CAN gatew ...

    Removal and Installation. Instrument Panel Assembly
    Exploded View 1. Speaker grille RH 2. Instrument garnish 3. Speaker grille LH 4. Instrument panel assembly 5. Instrument mask LH 6. Side ventilator grille assembly LH 7. Instrument pad A 8. Switch bracket B 9. Switch bracket A 10. Inst ...

    Automatic Brake Hold. Basic Inspection. Diagnosis and Repair Work Flow
    Diagnosis and Repair Work Flow Work Flow DETAILED FLOWINTERVIEW FROM THE CUSTOMER Clarify customer complaints before inspection. First of all, perform an interview utilizing Diagnostic Work Sheet and reproduce the symptom as well as fully understand it. Ask customer about his/her complaints ...