Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: Calibration of Automatic Back Door Position Information

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Door & Lock / Basic Inspection :: Calibration of Automatic Back Door Position Information

Description

When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system. Refer to Work Procedure.

  • After removing and installing, or replacing automatic back door control unit

  • After removing and installing, or replacing back door assembly

  • After removing and installing, or replacing spindle unit

Work Procedure

STEP 1

CONSULT

  1. Select “Reset auto back door status” in “Work supports” mode of "AUTOMATIC BACK DOOR".

  2. Touch “Start” to erase automatic back door position information.

>>

GO TO 2.

STEP 2

Fully close the back door manually.

>>

GO TO 3.

STEP 3

Operate back door opener switch and perform automatic open operation.

>>

GO TO 4.

STEP 4

  1. The back door fully opens.

  2. Check that automatic back door warning buzzer sounds normally.

Does automatic back door warning buzzer sound normally?

YES>>

GO TO 5.

NO>>

GO TO 2.

STEP 5

Fully close the back door.

>>

Work End.

    Basic Inspection. Configration (intelligent Key Unit)
    Description Vehicle specification needs to be written with CONSULT because it is not written after replacing the Intelligent Key unit.The configuration requires network connecti...
    Dtc/circuit Diagnosis. B2001-45 Intelligent Key Unit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2001-45 Intelligent Key unit (Intelligent Key unit) Diagnos...

    Other materials:

    P1564 Ascd Steering Switch
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1564 00 ASCD SW (ASCD SW) Diagnosis condition — Signal (terminal) ASCD steering switch signal Threshold ECM detects that input signal from t ...

    P11a9 Vcr Target Angle
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P11A9 00 VCR target angle (Variable compression ratio target angle) Diagnosis condition Engine running at idle Signal (terminal) — Threshold ...

    Service Data and Specifications (sds)
    Wheel Alignment Item Standard Camber Degree minute (Decimal degree) Minimum –1° 15′ (–1.25°) Nominal –0° 30′ (–0.50°) Maximum 0° 15′ (0.25°) Left and right difference *1 [–0° 33′ (–0.55°)] - [0° 33′ (0.55°)] Caster Degree mi ...