Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2001-45 Intelligent Key Unit

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content)
DTC Detection Condition
B2001-45

Intelligent Key unit

(Intelligent Key unit)
Diagnosis condition Ignition switch ON
Signal (terminal)
Threshold Intelligent Key unit is internal malfunctioning
Diagnosis delay time 1 second or less

POSSIBLE CAUSE

Intelligent Key unit

FAIL-SAFE

DTC CONFIRMATION PROCEDURE

DTC CONFIRMATION

CONSULT

  1. Erase DTC.

  2. Ignition switch OFF.

  3. Ignition switch ON.

  4. Select “Self diagnosis result” mode of “INTELLIGENT KEY”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO–1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO–2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

REPLACE INTELLIGENT KEY UNIT

When DTC “B2001-45” is detected, replace Intelligent Key unit.

>>

Replace Intelligent Key unit. Refer to Removal and Installation.

    Basic Inspection. Calibration of Automatic Back Door Position Information
    Description When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system. R...
    Dtc/circuit Diagnosis. B2010-1c Battery Voltage
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2010-1C Battery voltage (Battery voltage) Diagnosis conditi...

    Other materials:

    P0103 Maf Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0103 00 MAF SEN/CIRCUIT-B1 (Mass or volume air flow sensor "A" circuit high) Diagnosis condition Turn ignition switch ON Engine running at idle ...

    B2480-93 Rear Air Mix Door Motor
    DTC Description DTC DETECTION LOGICNOTE: If all of door motors DTC (B2480-93*, B24F5-93, B24F6-93, B24F7-93, B24F8-93) are detected, check “DOOR MOTOR”. Refer to Diagnosis Procedure. *: With rear air control DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection cond ...

    Symptom Diagnosis. Combination Switch System Symptoms
    Symptom Table Select “Data monitor” of CONSULT to check for any malfunctioning item. Check that the data monitor display switches in conjunction with the combination switch operation. If there is a switch whose display does not change, specify the applicable combination switch c ...