Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2010-1c Battery Voltage

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Door & Lock / Dtc/circuit Diagnosis :: B2010-1c Battery Voltage

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC Detection Condition
B2010-1C

Battery voltage

(Battery voltage) 		Diagnosis condition All times
Signal (terminal) Intelligent Key unit battery power supply signal
Threshold Less than 4 V or more than 16 V
Diagnosis delay time —

POSSIBLE CAUSE

  • Harness or connector (power supply circuit)

  • Intelligent Key unit

  • Battery

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

DTC CONFIRMATION

CONSULT

  1. Erase DTC.

  2. Ignition switch OFF.

  3. Ignition switch ON.

  4. Select “Self diagnosis result” mode of “INTELLIGENT KEY”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO–1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO–2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK BATTERY VOLTAGE

Measure the battery voltage. Refer to How to Handle Battery.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace battery.

CHECK POWER SUPPLY CIRCUIT

Check Intelligent Key unit power supply circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

Replace Intelligent Key unit. Refer to Removal and Installation.

NO>>

Repair the malfunctioning part.

    Dtc/circuit Diagnosis. B2001-45 Intelligent Key Unit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2001-45 Intelligent Key unit (Intelligent Key unit) Diagnos...
    Dtc/circuit Diagnosis. B203d-14 Inside Antenna
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B203D-14 Inside antenna (Inside antenna) Diagnosis condition...

    Other materials:

    Knock Sensor
    Component Inspection CHECK KNOCK SENSOR Turn ignition switch OFF. Disconnect knock sensor harness connector. Check resistance between knock sensor terminals as follows. NOTE: It is necessary to use an ohmmeter which can measure more than 10 MΩ. Knock sensor Condition Re ...

    Manual Air Conditioning. Symptom Diagnosis
    Air Conditioner Control-Manual Symptom Table NOTE: Perform "Self diagnosis result" with CONSULT before performing the symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis. Symptom Corresponding malfunction part Check item/Reference Air conditioning system doe ...

    Dtc/circuit Diagnosis. U1321-55 Configuration
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1321 55 Configuration data error (Configuration data error) Diagnosis condition When ignition switch is ON. Signal (terminal) — Threshold When ...