Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Back Door Opener Actuator

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Door & Lock / Dtc/circuit Diagnosis :: Back Door Opener Actuator

Component Function Check

CHECK FUNCTION

CONSULT

  1. Ignition switch ON.

  2. Select “Trunk/back door” in “Active test” mode of "BCM".

  3. Check that the function operates normally according to the following conditions.

    Monitor item Status
    Trunk/back door On Back door OPEN

Is the inspection result normal?

YES>>

Back door opener actuator is OK.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK BACK DOOR OPENER ACTUATOR INPUT SIGNAL

  1. Ignition switch OFF.

  2. Disconnect back door lock assembly connector.

  3. Check voltage between back door lock assembly harness connector and ground.

(+) (–) Condition

Voltage

(Approx.)
Back door lock assembly
Connector Terminal
D508 4 Ground Back door opener switch ON Battery voltage

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

GO TO 2.

CHECK BACK DOOR OPENER ACTUATOR CIRCUIT

  1. Disconnect BCM connector.

  2. Check continuity between BCM harness connector and back door lock assembly harness connector.

    BCM Back door lock assembly Continuity
    Connector Terminal Connector Terminal
    B27 145 D508 4 Yes

  3. Check continuity between BCM harness connector and ground.

    BCM — Continuity
    Connector Terminal
    B27 145 Ground No

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair or replace harness.

CHECK BACK DOOR OPENER ACTUATOR GROUND CIRCUIT

Check continuity between back door lock assembly harness connector and ground.

Back door lock assembly — Continuity
Connector Terminal
D508 3 Ground Yes

Is the inspection normal?

YES>>

Replace back door lock assembly. Refer to Removal and Installation.

NO>>

Repair or replace harness.

    Dtc/circuit Diagnosis. Back Door Switch
    Component Function Check CHECK FUNCTION CONSULT Ignition switch ON. Select “Back door/trunk lid switch” in “Data monitor” mode of "BCM [TRUNK]". Check that the function ...
    Dtc/circuit Diagnosis. Back Door Opener Switch
    Component Function Check CHECK FUNCTION CONSULT Ignition switch ON. Select “Request switch back door/trunk lid” in “Data monitor” mode of "BCM [TRUNK]". Check that the f...

    Other materials:

    P0090 Frp System
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0090 00 FUEL PUMP (Fuel Pressure Regulator "A" Control Circuit/Open) Diagnosis condition Engine running at idle Signal (terminal) High pressure fuel p ...

    Removal and Installation. Vacuum Lines
    Exploded View Brake booster Clamp Vacuum hose 1 Vacuum pump Vacuum hose 2 Clip Intake manifold Check valve     Paint mark (White) Paint mark (Pink) Paint mark (Yellow) Stamp indicating the direction of engine (Yellow) & ...

    Removal and Installation. Sunshade Motor Assembly
    Exploded View Refer to Exploded View. Removal and Installation REMOVALCAUTION: Before removing sunshade motor, check that sunshade is fully opened. After removing sunshade motor, never attempt to rotate sunshade motor assembly as a single unit. Remove headlining to make work space. ...