Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: Additional Service When Replacing Intelligent Key Unit

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Door & Lock / Basic Inspection :: Additional Service When Replacing Intelligent Key Unit

Description

CAUTION:

When replacing the Intelligent Key unit, always replace it with a new one. The functions controlled by the Intelligent Key unit does not operate properly in case of reuse of the Intelligent Key unit from another Nissan Ariya vehicle.

Perform the following operations when replacing Intelligent Key unit. For details, refer to Work Procedure.

AFTER REPLACEMENT

CAUTION:

After replacing Intelligent Key unit, the following must be performed. Or not doing so, Intelligent Key unit control function does not operate normally.

  • Writing Nissan Ariya vehicle specification

  • Register Intelligent Keys

Work Procedure

REPLACE INTELLIGENT KEY UNIT

Replace Intelligent Key unit. Refer to Removal and Installation.

>>

GO TO 2.

WRITING Nissan Ariya Vehicle SPECIFICATION

CONSULT Configuration

Perform configuration. Refer to Description.

>>

GO TO 3.

REGISTER INTELLIGENT KEYS

For initialization and registration of Intelligent Key: Refer to CONSULT Immobilizer mode and follow the on-screen instructions.

NOTE:

If customer has Virtual I-Key application, reprogram and register it as a third keyfob, and follow same configuration as Nissan Ariya vehicle Intelligent Key.

>>

WORK END

    Basic Inspection. Diagnosis and Repair Work Flow
    Work Flow OVERALL SEQUENCEDETAILED FLOWGET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incid...
    Basic Inspection. Additional Service When Replacing Automatic Back Door Control Unit
    Description When replacing automatic back door control unit necessary to perform initial setting to operate automatic back door system normally. Refer to Work Procedure. Work Pr...

    Other materials:

    Rear window and outside mirror defroster switch
    Example To defog or defrost the rear window and outside mirrors (if equipped), start the engine and press the switch. The indicator light A illuminates. Press again to turn the system off. The system turns off automatically after approximately 20 minutes. CAUTION When cleaning the inside of the ...

    Power Supply and Ground Circuit
    Diagnosis Procedure CHECK FUSE Check that the following fuse is not blown: Signal name Fuse No. Ignition power supply 40 (10 A) Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit. NO>> GO TO 2. CHECK ADAS CONTROL UNIT 2 POWER SUPP ...

    P10c8 Internal Control Module Fuel Injector
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P10C8 00 Cylinder1 injector A (Cylinder1 injector A) Diagnosis condition — Signal (terminal) — Threshold Injector driver unit is malfu ...