Nissan Rogue (T33) 2021-Present Service Manual: B2e12-55 Configuration

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Audio, Visual & Navigation System / Telematics System :: Dtc/circuit Diagnosis / B2e12-55 Configuration

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
B2E12-55

Configuration

(Configuration) 		Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Configuration not complete
Diagnosis delay time 1 second or more

POSSIBLE CAUSE

  • System configuration has not been made or is in complete.

  • TCU

FAIL-SAFE

TCU has not been initialized

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “IVC” using CONSULT.

  5. Check DTC.

Is DTC B2E12‐55 detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

PERFORM CONFIGURATION

When B2E12–55 is detected, perform configuration of TCU. Refer to Work Procedure.

>>

GO TO 2.

PERFORM CONFIRMATION PROCEDURE AGAIN

With CONSULT

  1. Turn ignition switch ON.

  2. Erase DTC.

  3. Perform confirmation procedure again. Refer to DTC Description.

Is DTC B2E12–55 detected?

YES>>

Replace TCU. Refer to Removal & Installation.

NO>>

INSPECTION END

    B2e08-01 Microphone
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E08–01 Microphone (Microphone) 1 Diagnosis condition Whe...
    B2e1b-97 Automatic Ecall
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition B2E1B-97 Automatic eCall locked Diagnosis condition When ignition switch is ON Signal (t...

    Other materials:

    Lane Change Assist
    Basic information Lane Change Assist is a feature of ProPILOT Assist 2.1 on the Nissan Rogue. Read the entire ProPILOT Assist section before using this system, including how to operate it and how to interpret the display. When ProPILOT Assist is active and the status indicator A is illuminated in ...

    Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses
    Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any of customer's comments. Refer to Diagnostic Work ...

    Diagnosis System [abs Actuator and Electric Unit (control Unit)]
    CONSULT Function APPLICATION ITEMSCONSULT can display each diagnostic item using the diagnostic test modes as follows. Diagnosis mode CGW Status Description Restricted Mode Diag Test Mode Open Mode Self Diagnosis Result Display Display Display Display non-network DTC which ABS ...