Nissan Rogue (T33) 2021-Present Service Manual: B2e1b-97 Automatic Ecall

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Audio, Visual & Navigation System / Telematics System :: Dtc/circuit Diagnosis / B2e1b-97 Automatic Ecall

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detection condition
B2E1B-97 Automatic eCall locked Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Automatic report function of the TCU is activated
Diagnosis delay time 1 second or more

POSSIBLE CAUSE

Automatic report function of the TCU is activated

FAIL-SAFE

Automatic emergency call does not operate

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “IVC” using CONSULT.

  5. Check DTC.

Is DTC B2E1B-97 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

PERFORM AUTOMATIC REPORT PREVENTION RELEASE

Perform automatic report prevention release when DTC B2E1B-97 is detected.

>>

Perform "Automatic report prevention release". Refer to Work Procedure.

    B2e12-55 Configuration
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E12-55 Configuration (Configuration) Diagnosis condition W...
    B2e32-11 Av Control Unit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E32-11 Audio unit (Audio unit) Diagnosis condition When ig...

    Other materials:

    Dtc/circuit Diagnosis. Reclining Sensor
    Component Function Check CHECK FUNCTION CONSULT Ignition switch ON. Select “Reclining motor position” in “Data monitor” mode of “DRIVER SEAT”. Check reclining sensor signal under the following conditions. Monitor item Condition Status Reclining motor position ...

    A/f Sensor 1
    Component Function Check PERFORM COMPONENT FUNCTION CHECK With GST Start engine and warm it up to normal operating temperature. Drive the Nissan Ariya vehicle at a speed of 80 km/h (50 MPH) for a few minutes in the suitable gear position. Shift the selector lever to the D position, ...

    Power Supply and Ground Circuit
    A/c Amp. Diagnosis Procedure CHECK A/C AMP. GROUND CIRCUIT FOR OPEN Ignition switch OFF. Disconnect A/C amp. connector. Check continuity between A/C amp. harness connector and ground. A/C amp. (—) Continuity Connector Terminal M55 58 Ground Yes Is t ...