Nissan Rogue (T33) 2021-Present Service Manual: B2e32-11 Av Control Unit
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B2E32-11 |
Audio unit (Audio unit) |
Diagnosis condition | When ignition switch is ON |
| Signal (terminal) | Sound signal | ||
| Threshold | 0.5 V or less | ||
| Diagnosis delay time | 1 second or more | ||
POSSIBLE CAUSE
-
Sound signal circuit is short to ground
-
AV control unit
FAIL-SAFE
Telematics sound is not output
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “IVC” using CONSULT.
-
Check DTC.
Is DTC B2E32‐11 detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK TEL VOICE SIGNAL CIRCUIT
-
Turn ignition switch OFF.
-
Disconnect AV control unit and TCU harness connector.
-
Check the continuity between AV control unit harness connector and ground.
AV control unit Ground Continuity Connector Terminal M102*1
M124*232 Not existed 52 *1: Without BOSE
*2: With BOSE
Is the inspection result normal?
YES>>Replace AV control unit. Refer to Removal and Installation.
NO>>Repair or replace harness or connector.
Other materials:
P161f Immobilizer
DTC Description
DTC DETECTION LOGICNOTE:
DTC P161F is displayed with another ECU.
Perform the trouble diagnosis for the corresponding DTC of another ECU. Refer to DTC Description.
POSSIBLE CAUSE
ECM
Intelligent Key unit
Electric shift control module
Power steering control modul ...
Cvt: Ge0f14a. Basic Inspection
Diagnosis and Repair Work Flow
Work Flow
NOTE:
“DTC” includes DTC at the 1st trip.
OBTAIN INFORMATION ABOUT SYMPTOM
Refer to Diagnostic Work Sheet and interview the customer to obtain
the malfunction information (conditions and environment when the
malfunction occurred) as much as possi ...
P0010 Intake Valve Timing Control
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0010
00
A camshaft position actuator B1
(“A” camshaft position actuator control circuit/open bank 1)
Diagnosis condition
Ignition switch ON
Signal (t ...
