Nissan Rogue (T33) 2021-Present Service Manual: B2e49-06 Remote Actuator

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Audio, Visual & Navigation System / Telematics System :: Dtc/circuit Diagnosis / B2e49-06 Remote Actuator

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
B2E49–06

Remote actuator not activated

(Remote actuator not activated) 		Diagnosis condition When receiving remote command
Signal (terminal) —
Threshold Remote service has not been activated
Diagnosis delay time —

POSSIBLE CAUSE

Remote service has not been activated

FAIL-SAFE

Remote function does not operate

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Operate the remote function of the telematics system.

  5. Select “Self Diagnostic Result” mode of “IVC” using CONSULT.

  6. Check DTC.

Is DTC B2E49-06 detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

PERFORM CONFIRMATION PROCEDURE AGAIN

With CONSULT

  1. Turn ignition switch ON.

  2. Erase DTC.

  3. Perform confirmation procedure again. Refer to DTC Description.

Is DTC B2E49‐06 detected?

YES>>

Replace TCU. Refer to Removal & Installation.

NO>>

Refer to Intermittent Incident.

    B2e32-11 Av Control Unit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E32-11 Audio unit (Audio unit) Diagnosis condition When ig...
    U0074-00 Av Communication
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0074-00 Control module comm Bus B Off (Control module commu...

    Other materials:

    Removal and Installation. Automatic Back Door Lock and Close Switch Assembly
    Removal and Installation REMOVALRemove automatic back door lock and close switch assembly and automatic back door close switch finisher. Refer to Removal and Installation. Remove automatic back door lock and close switch assembly fixing screws and then remove automatic back door lock and clos ...

    Adas Control Unit. Basic Inspection
    Additional Service When Replacing Adas Control Unit 2 Without Propilot Assist 2.1 Work Procedure Always perform the additional service after replacing the ADAS control unit 2.ADAS CONTROL UNIT 2 CONFIGURATION Perform saving Nissan Ariya vehicle internal information according to "Replace ECU" i ...

    Dtc/circuit Diagnosis. Eps Warning Lamp
    Component Function Check CHECK THE ILLUMINATION OF THE ELECTRIC POWER STEERING WARNING LAMP Check that the electric power steering warning lamp turns ON when ignition switch ON. Then, electric power steering warning lamp turns OFF after the engine is started. Is the inspection result normal? ...