Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Touch Sensor

Component Inspection

CHECK TOUCH SENSOR

  1. Ignition switch OFF.

  2. Disconnect touch sensor connector.

  3. Check resistance between touch sensor terminals.

Touch sensor Condition Resistance
Terminal
1 4 Touch sensor Detect obstruction 400 - 100 Ω
Other than above 0.95 – 1.05 kΩ

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace touch sensor. Refer to Removal and Installation.

    Dtc/circuit Diagnosis. Power Supply and Ground Circuit
    Front Door Lock Diagnosis Procedure CHECK FUSE Check that the following fuse is not blown (open). Signal name Fuse No. Front door lock actuator power supply 12 (10 A) Is the fus...
    Dtc/circuit Diagnosis. Unlock Sensor
    Diagnosis Procedure CHECK UNLOCK SENSOR INPUT SIGNAL Ignition switch OFF. Disconnect front door lock assembly LH connector. Check voltage between front door lock assembly LH har...

    Other materials:

    U1caa-02 Mode Door Motor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1CAA-02 Mode door motor (Mode door motor) Diagnosis condition Ignition switch ON Signal (Terminal) LIN (door motor) signal Threshold A/C amp. is no ...

    Awd. Periodic Maintenance
    Rear Wheel Hub and Housing Inspection COMPONENT PARTMake sure that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)Check the following items, and replace the part if necessary. Mov ...

    Forward-facing child restraint installation using LATCH
    Basic information For proper installation of a forward-facing child restraint in your Nissan Rogue, carefully review all Warnings and Cautions in the “Child safety” and “Child restraints” sections before beginning. Do not use the lower anchors if the combined weight of the child and res ...