Nissan Rogue (T33) 2021-Present Service Manual: B2740-82 Ipdm E/r
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2740-82 | IPDM E/R | Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | — | |||
| Threshold | Communication error between sonar control unit and IPDM E/R | |||
| Diagnosis delay time | 2 seconds or more | |||
POSSIBLE CAUSE
-
Sonar control unit
-
IPDM E/R
FAIL-SAFE
—
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 2 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2740-82” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK SELF-DIAGNOSTIC RESULT OF IPDM E/R
With CONSULT
Check “Self Diagnostic Result” of “IPDM E/R” using CONSULT.
Is any DTC detected?
YES>>Perform trouble diagnosis for detected DTC. Refer to DTC Index.
NO>>GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With CONSULT
-
Turn ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC B2740-82 detected again?
YES>>Replace sonar control unit. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
P00f2 Maf Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P00F2
00
Humidity Sensor Circuit/Open
(Humidity Sensor Circuit/Open)
Diagnosis condition
—
Signal (terminal)
Humidity sensor signal
Threshold ...
Multi Remote Ent
CONSULT Function (BCM - MULTI REMOTE ENT)
DATA MONITORNOTE:
The following table includes information (items)
inapplicable to this Nissan Ariya vehicle. For information (items)
applicable to this vehicle, refer to CONSULT display items.
Monitor Item Condition
Stop/start switch
[On/Off] ...
Symptom Diagnosis. Panic Alarm Function Does Not Operate
Description
Panic alarm does not operate when press the PANIC ALARM button of Intelligent Key.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM (REMOTE KEYLESS ENTRY FUNCTION)
Press the LOCK button of Intelligent Key.
Are all doors LOCKED?
YES>>
GO TO 2.
NO>>
Check Intelligent ...
