Nissan Rogue (T33) 2021-Present Service Manual: B2740-87 Ipdm E/r

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
B2740-87 IPDM E/R Diagnosis condition When ignition switch is ON
Signal (terminal) CAN communication signal
Threshold Sonar control unit cannot communicate CAN communication signal
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Sonar control unit

  • IPDM E/R

FAIL-SAFE

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait for 30 seconds.

  3. Turn ignition switch ON and wait at least 2 seconds or more.

  4. Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.

  5. Check DTC.

Is DTC B2740-87 detected?

YES>>

Proceed to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

With CONSULT

  1. Turn ignition switch ON.

  2. Erase DTC.

  3. Perform DTC confirmation procedure again. Refer to DTC Description.

Is DTC B2740-87 detected again?

YES>>

Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

NO>>

INSPECTION END

    B2740-82 Ipdm E/r
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2740-82 IPDM E/R Diagnosis condition When ignition switch is ON...
    B2755-94 Front Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2755-94 Front sensor (Front sensor) Diagnosis condition Whe...

    Other materials:

    Comb Sw
    CONSULT Function (BCM - COMB SW) DATA MONITORNOTE: The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Monitor item [Unit] Description Rear wiper ON [On/Off] ...

    P11a2 Vcr Motor Rotation Angle Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P11A2 00 VCR motor rotation angle sensor (Variable compression ratio motor rotation angle sensor) Diagnosis condition Ignition switch ON Signal (terminal) VC ...

    Dlc Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). Data link connector 8CH CAN gatew ...