Nissan Rogue (T33) 2021-Present Service Manual: B2755-94 Front Sensor
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B2755-94 |
Front sensor (Front sensor) |
Diagnosis condition | When ignition switch is ON |
| Signal (terminal) | Front sensor signal | ||
| Threshold | Persistent noise | ||
| Diagnosis delay time | 1 seconds or more | ||
POSSIBLE CAUSE
Persistent noise in the front sensors ultrasonic range (exhaust sound, heavy rain, horn) not filtered out by signal processing.
FAIL-SAFE
Obstacle detection function is deactivated.
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait for 30 seconds.
-
Turn ignition switch ON and wait at least 2 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check DTC.
Is DTC B2755-94 detected?
YES>>Proceed to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK FRONT SENSORS
Check the front sensor for dirt and damage.
Is inspection result normal?
YES>>GO TO 2.
NO>>PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With CONSULT
-
Turn ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC B2755-94 detected again?
YES>>Replace front sensors. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
P0532 A/c Refrigerant Pressure Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0532
00
REFRIGERANT PRESS SENSOR A
(A/C refrigerant pressure sensor A circuit low)
Diagnosis condition
—
Signal (terminal)
Refrigerant pressure sens ...
C106f-54 Steering Angle Sensor
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C106F
54
Steering angle sensor
(Steering angle sensor)
Diagnosis condition
When ignition switch is ON.
When the power supply voltage is normal.
...
Electric Wastegate Control Actuator
Component Inspection
INSPECTION START
Do you have CONSULT?
Do you have CONSULT?
YES>>
GO TO 2.
NO>>
GO TO 3.
CHECK ELECTRIC WASTEGATE CONTROL ACTUATOR
With CONSULT
Turn ignition switch ON and engine stopped.
On the CONSULT screen, select “ENGINE”>>“ACTIVE ...
