Nissan Rogue (T33) 2021-Present Service Manual: B2720-16 Corner Sensor [rl]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2720-16 |
CORNER SENSOR [RL] (Corner sensor [rear left]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | Rear sonar sensor LH outer power supply | |||
| Threshold | More than 27 V | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
-
Harness and connector between sonar control unit and rear sonar sensor LH outer
-
Sonar control unit
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2720–16” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK REAR SONAR SENSOR POWER SUPPLY
Check rear sonar sensor power supply circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Repair or replace malfunctioning parts.
Other materials:
Transfer: Ty92a. Symptom Diagnosis
Heavy Tight-Corner Braking Symptom Occurs
Description
Heavy tight-corner braking symptom occurs when the vehicle is driven
and the steering wheel is turned fully to either side after the engine
is started.NOTE:
Light tight-corner braking symptom may occur depending on driving conditions. This ...
Blind Spot Warning (BSW)
Basic information
WARNING
Failure to follow the warnings and instructions for proper use of the Blind Spot Warning system could result in serious injury or death.
The BSW system is not a substitute for safe driving practices. It cannot prevent collisions with nearby vehicles or objects. Always c ...
P2237 Ho2s2
DTC Description
To judge malfunctions, the diagnosis checks that the A/F signal
computed by ECM from the A/F sensor 1 signal fluctuates according to
fuel feedback control.DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P2237
00
...
