Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2c95-64 Combination Switch

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / Dtc/circuit Diagnosis :: B2c95-64 Combination Switch

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC Detection Condition
B2C95-64

Combination switch

(Combination switch) 		Diagnosis condition Ignition switch OFF (auto ACC status)
Signal (terminal) Combination switch signal
Threshold BCM detects the combination switch check diode positions stuck at ON for 2 seconds or more
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Harness or connector (combination switch circuit is short to battery)

  • Combination switch

  • BCM

FAIL-SAFE

Turns ON the headlamp (LO)

DTC CONFIRMATION PROCEDURE

CHECK SELF-DIAG RESULT

CONSULT

  1. Erase DTC.

  2. Ignition switch OFF.

  3. Select “Self diagnosis result” mode of "BCM", when 2 seconds or more passed after the ignition switch is placed OFF (auto ACC status).

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK COMBINATION SWITCH SYSTEM SYMPTOMS

Perform COMBINATION SWITCH SYSTEM SYMPTOMS. Refer to Symptom Table.

>>

Inspection End.

    Dtc/circuit Diagnosis. B2c95-01 Combination Switch
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2C95-01 Combination switch (Combination switch) Diagnosis c...
    Dtc/circuit Diagnosis. U0073-00 Control Module Comm Bus a Off
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line...

    Other materials:

    U0074-00 Av Communication
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0074-00 Control module comm Bus B Off (Control module communication bus B off) Diagnosis condition When ignition switch is ON Signal (terminal) AV communic ...

    P0365 Exhaust Camshaft Position Sensor
    DTC Description DTC DETECTION LOGIC Exhaust camshaft position sensor signal is not sent to ECM during engine running. The pulse signal sent from the exhaust camshaft position sensor to ECM is not in the normal pattern during engine running. DTC CONSULT screen terms (Trouble diagnos ...

    Service After Replacing or Removing Engine Parts
    Description X: Applicable Part name Service performed Required service Reference Replacement Removal   ECM X — Additional service when replacing ECM Work Procedure Fuel injector offset learning Work Procedure Turbocharger wastegate control solenoid valve d ...