Nissan Rogue (T33) 2021-Present Service Manual: B2720-11 Corner Sensor [rl]

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2720-11

CORNER SENSOR [RL]

(Corner sensor [rear left])
Diagnosis condition When ignition switch is ON
Signal (terminal) Rear sonar sensor signal LH outer
Threshold Short to ground
Diagnosis delay time 4 seconds or more

POSSIBLE CAUSE

  • Harness and connector between sonar control unit and rear sonar sensor LH outer

  • Rear sonar sensor LH outer

FAIL-SAFE

Stop the obstacle detection function

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.

  5. Check the DTC.

Is DTC “B2720–11” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK REAR SONAR SENSOR SIGNAL LH OUTER CIRCUIT (SHORT)

  1. Turn ignition switch OFF.

  2. Disconnect sonar control unit connector and rear sonar sensor LH outer connector.

  3. Check continuity between sonar control unit harness connector and ground.

Sonar control unit Ground Continuity
Connector Terminal
B20 22 Not existed

Is the inspection result normal?

YES>>

Replace the rear sonar sensor LH outer. Refer to Removal and Installation.

NO>>

Repair the harness or connector.

    B2720-05 Corner Sensor [rl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2720-05 CORNER SENSOR [RL] (Corner sensor [rear left]) Diagnosi...
    B2720-16 Corner Sensor [rl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2720-16 CORNER SENSOR [RL] (Corner sensor [rear left]) Diagnosi...

    Other materials:

    P26a5 Multi-Way Control Valve Position Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P26A5 00 ENGINE COOLANT B/V A POSI SEN (Engine coolant bypass valve A position sensor circuit range/performance) Diagnosis condition — Signal (terminal) Mu ...

    P2610 Ecm Internal Timer
    DTC Description DESCRIPTIONThis ECM contains a timer and measures time between an ignition switch OFF and the next ignition switch ON. This enables the judging of the state of engine cooling at an engine start.DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC ...

    Crankshaft Position Sensor
    Component Inspection CHECK CRANKSHAFT POSITION SENSOR (POS)-1 Turn ignition switch OFF. Loosen the fixing bolt of the sensor. Disconnect crankshaft position sensor (POS) harness connector. Remove the sensor. Visually check the sensor for chipping. Is the inspection r ...