Nissan Rogue (T33) 2021-Present Service Manual: B24b4-02 A/c Control Comm

Nissan Rogue (T33) 2021-Present Service Manual / Ventilation, Heater & Air Conditioner :: Heater & Air Conditioning Control System / Manual Air Conditioning :: Dtc/circuit Diagnosis / B24b4-02 A/c Control Comm

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
B24B4-02

A/C CONTROL COMM

(Air conditioning control communication) 		Diagnosis condition Ignition switch ON
Signal (Terminal) LIN (A/C switch assembly) signal
Threshold Receive internal circuit error message via A/C switch assembly to LIN communication
Diagnosis delay time 30 second or more

POSSIBLE CAUSE

A/C switch assembly (internal circuit malfunction)

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM SELF DIAGNOSIS

CONSULT

  1. Ignition switch ON.

  2. Select "Self diagnosis result" mode of "HVAC".

  3. Check DTC.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

PERFORM SELF DIAGNOSIS RESULT

CONSULT

  1. Ignition switch ON.

  2. Select "Self diagnosis result" mode of "HVAC".

  3. Touch “ERASE”.

  4. Ignition switch OFF.

  5. Ignition switch ON.

  6. Perform “DTC CONFIRMATION PROCEDURE”. Refer to DTC Description.

Is DTC detected again?

YES>>

Replace A/C switch assembly. Refer to Removal and Installation.

NO>>

Inspection End.

    B24a4-11 Intake Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24A4-11 INTAKE SENSOR (Intake sensor) Diagnosis condition I...
    B24c6-12 Blower Motor Control
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24C6–12 BLOWER MOTOR CONTROL (Blower motor control) [CIRC...

    Other materials:

    Switching Signal Circuit
    Side Radar Front Rh Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Check the terminals and connectors of the side radar front LH/RH for damage, bend and short (unit side and connector side). Is the inspection result normal? YES>> GO TO 2. NO>> ...

    It Can Communication 3 Circuit
    Diagnosis Procedure CHECK NETWORK DIAGNOSIS Check the "Network diagnosis" results from CONSULT to see that the diagnostic CAN communication circuit have no malfunction. Are the diagnostic CAN communication circuit normal? YES>> GO TO 2. NO>> Check and repair diagnostic CAN commu ...

    Dtc/circuit Diagnosis. Front Wiper Motor Ground Circuit
    Diagnosis Procedure CHECK FRONT WIPER MOTOR GROUND CIRCUIT Ignition switch OFF. Disconnect front wiper motor connector. Check continuity between front wiper motor harness connector and ground. Front wiper motor (—) Continuity Connector Terminal E20 2 Ground Yes ...