Nissan Rogue (T33) 2021-Present Service Manual: B24a0-49 A/c Auto Amp.

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
B24A0-49

A/C AUTO AMP.

(Air conditioning automatic amplifier)
Diagnosis condition Ignition switch ON
Signal (Terminal)
Threshold A malfunction is detected in A/C amp. internal EEPROM memory functions.
Diagnosis delay time 2 second or more

POSSIBLE CAUSE

A/C amp.

FAIL-SAFE

DTC CONFIRMATION PROCEDURE

PERFORM SELF DIAGNOSIS

CONSULT

  1. Ignition switch ON.

  2. Select "Self diagnosis result" mode of "HVAC".

  3. Check DTC.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

REPLACE A/C AMP.

Replace A/C amp. Refer to Removal and Installation.

>>

Inspection End.

    B20c8-14 Ecv (electrical Control Valve)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B20C8–14 Compressor (ECV) [Compressor (electrical control ...
    B24a1-16 A/c Auto Amp. Power Supply
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24A1-16 A/C AUTO AMP. POWER SUPPLY (Air conditioning automa...

    Other materials:

    P2239 Ho2s2
    DTC Description To judge malfunctions, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal fluctuates according to fuel feedback control.DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2239 00 ...

    Exit Assist Function
    System Description SYSTEM DIAGRAMSeveral types of signals are transmitted from the following units to the driver seat control unit via CAN communication.INPUT SIGNAL AND OUTPUT SIGNAL Component Signal ABS actuator and electric unit (control unit) Nissan Ariya Vehicle speed signal BCM ...

    Ignition Coil with Power Transistor
    Component Inspection CHECK IGNITION COIL WITH POWER TRANSISTOR-1 Turn ignition switch OFF. Disconnect ignition coil harness connector. Check resistance between ignition coil terminals as per the following. Ignition coil Condition Resistance + − Terminal 1 ...