Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: Configuration (air Bag Diagnosis Sensor Unit)

Nissan Rogue (T33) 2021-Present Service Manual / Restraints :: Srs Air Bag Control System / Basic Inspection :: Configuration (air Bag Diagnosis Sensor Unit)

Description

Vehicle specification needs to be written with CONSULT because it is not written after replacing the air bag diagnosis sensor unit.

The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the Nissan Ariya vehicle specification to the air bag diagnosis sensor unit.

Refer to Work Procedure.

NOTE:

For details the network connection and operation, refer to “CONSULT Operation Manual”.

The configuration no need to “save” configuration data from the air bag diagnosis sensor unit. The configuration data is always generated freshly at the server and then downloaded to the CONSULT.

CAUTION:

  • Complete the procedure of “Configuration” in order.

  • If incorrect “Configuration”, incidents might occur.

Work Procedure

WRITING VEHICLE SPECIFICATION

CONSULT

Perform writing Nissan Ariya vehicle specification to air bag diagnosis sensor unit following "Automatic Configuration" procedure of "Configuration" according to CONSULT Operation Manual.

NOTE:

  • Log in the network according to CONSULT guidance.

  • For details the network connection and operation, refer to “CONSULT Operation Manual”.

>>

GO TO 2

CHECK ALL ECU SELF-DIAGNOSIS RESULTS

CONSULT

  1. Erase all ECU self-diagnosis results using CONSULT.

  2. Ignition switch OFF.

  3. Ignition switch ON.

  4. Check that all ECU self-diagnosis results have no DTC.

>>

Inspection End

    Basic Inspection. Additional Service When Replacing Air Bag Diagnosis Sensor Unit
    Description After replaced air bag diagnosis sensor unit, it is necessary to perform control unit configuration with CONSULT. For details, refer to Work Procedure. Work Procedur...
    Basic Inspection. Additional Service When Replacing Occupant Detection System Control Unit
    Description When replacing or removing and installing passenger seat, always perform zero point reset so that occupant detection system is activated normally. Refer to Work Proc...

    Other materials:

    P2123 App Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2123 00 APP SEN 1/CIRC (Throttle/Pedal position sensor/switch D circuit high) Diagnosis condition Engine running at idle Signal (terminal) Accelerator ...

    Fonctionnement du système LDW
    Témoin LDW (affiché sur l’écran d’informations du véhicule) Écran d’informations du véhicule Commandes au volant (côté gauche) Le système LDW du Nissan Rogue active la fonction d’alerte sortie de voie lorsque la vitesse du véhicule atteint environ 60 km/h (37 mi ...

    P11aa Vcr Position Learning
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P11AA 00 VCR position learning (Variable compression ratio position learning) Diagnosis condition Ignition switch ON Signal (terminal) — Thresho ...