Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: Additional Service When Replacing Occupant Detection System Control Unit

Nissan Rogue (T33) 2021-Present Service Manual / Restraints :: Srs Air Bag Control System / Basic Inspection :: Additional Service When Replacing Occupant Detection System Control Unit

Description

When replacing or removing and installing passenger seat, always perform zero point reset so that occupant detection system is activated normally. Refer to Work Procedure.

Work Procedure

PERFORM ZERO POINT RESET

Perform zero point reset. Refer to Description.

>>

Inspection End

    Basic Inspection. Configuration (air Bag Diagnosis Sensor Unit)
    Description Vehicle specification needs to be written with CONSULT because it is not written after replacing the air bag diagnosis sensor unit.The configuration requires network...
    Basic Inspection. Zero Point Reset
    Description Zero point reset is an initializing procedure for occupant detection system sensor that must be performed when replacing or removing and installing passenger seat.If...

    Other materials:

    On Board Diagnostic (obd) System
    Diagnosis Description This system is an on board diagnostic system that records exhaust emission-related diagnostic information and detects a sensors/actuator-related malfunction. A malfunction is indicated by the malfunction indicator lamp (MIL) and stored in ECU memory as a DTC. The diagn ...

    Limites du système de détecteur de collision frontale intelligent
    Illustration A Illustration B Illustration C Illustration D AVERTISSEMENT Les limites du système de détecteur de collision frontale intelligent du Nissan Rogue sont décrites ci-dessous. Le non-respect de ces limites lors de la conduite peut entraîner des blessures gr ...

    Engine oil
    Checking engine oil level Park the vehicle on a level area and apply the parking brake. Warm up the engine to operating temperature. Shut the engine off and wait at least 10 minutes. Remove the dipstick, wipe it clean, then fully reinsert it. Remove the dipstick again and check the oil le ...