Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Remote Engine Start Function Does Not Operate
Description
Engine does not start when operating REMOTE ENGNE START button of Intelligent Key.
NOTE:
Check that vehicle is under the condition shown in “Conditions of Nissan Ariya vehicle” before starting diagnosis, and check each symptom.
Conditions of Vehicle (Operating Conditions)
-
Shift position is in P position.
-
Vehicle security system is not in operation.
-
Registered Intelligent Key is not in the Nissan Ariya vehicle.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM (REMOTE KEYLESS ENTRY FUNCTION)
Lock/unlock door with Intelligent Key. Refer to System Description.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Check Intelligent Key system (remote keyless entry function). Refer to Diagnosis Procedure.
CHECK HOOD SWITCH
Check hood switch. Refer to Component Function Check.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace malfunctioning parts.
CHECK DOOR SWITCH
Check door switch. Refer to Component Function Check.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair or replace malfunctioning parts.
CHECK HAZARD SWITCH
Check hazard switch. Refer to Component Function Check.
Is the inspection result normal?
YES>>GO TO 5.
NO>>Repair or replace malfunctioning parts.
REPLACE BCM
Replace BCM. Refer to Removal and Installation.
Is the inspection result normal?
YES>>Inspection End.
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials:
Restraints. Seat Belt Control System
Precaution :: Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along with a front seat belt, helps to reduce the
risk or severity of injury to t ...
Refrigerant Pressure Sensor
Component Function Check
CHECK REFRIGERANT PRESSURE SENSOR FUNCTION
Start engine and warm it up to normal operating temperature.
Turn A/C switch and blower fan switch ON.
Check the voltage between ECM harness connector terminals under the following conditions.
ECM Voltage
Conne ...
Front Oil Seal
Removal and Installation
REMOVALRemove the drive belt. Refer to Removal and Installation.
Remove the fender protector. Refer to Removal and Installation.
Remove crankshaft pulley using the following procedure:Loosen crankshaft pulley bolt.
CAUTION:
Do not remove the crankshaft pulley bolt as it ...
