Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: Additional Service When Replacing Air Bag Diagnosis Sensor Unit

Nissan Rogue (T33) 2021-Present Service Manual / Restraints :: Srs Air Bag Control System / Basic Inspection :: Additional Service When Replacing Air Bag Diagnosis Sensor Unit

Description

After replaced air bag diagnosis sensor unit, it is necessary to perform control unit configuration with CONSULT. For details, refer to Work Procedure.

Work Procedure

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

Replace air bag diagnosis sensor unit. Refer to Removal and Installation.

>>

GO TO 2.

WRITING Nissan Ariya Vehicle SPECIFICATION

Perform configuration for air bag diagnosis sensor unit. Refer to Description.

>>

Inspection End

    Basic Inspection. Diagnosis and Repair Work Flow
    Work Flow OVERALL SEQUENCEDETAILED FLOWGET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incid...
    Basic Inspection. Configuration (air Bag Diagnosis Sensor Unit)
    Description Vehicle specification needs to be written with CONSULT because it is not written after replacing the air bag diagnosis sensor unit.The configuration requires network...

    Other materials:

    Dtc/circuit Diagnosis. Seat Memory Switch
    Component Function Check CHECK FUNCTION CONSULT Ignition switch ON. Select “Memory switch 1”, “Memory switch 2” and “Set switch” in “Data monitor” mode of “DRIVER SEAT”. Check seat memory switch signal under the following conditions. Monitor item Conditio ...

    Propilot Assist 1.1. Removal and Installation
    Propilot Assist 1.1 Steering Switch Removal and Installation REMOVALFor servicing the Japan production ProPILOT Assist 1.1 steering switch, service the Japan production steering wheel. Refer to Removal and Installation.NOTE: The Japan production ProPILOT Assist 1.1 steering switch is servic ...

    Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses
    Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any of customer's comments; Refer to Diagnostic Work ...