Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2033-4a Dongle Ng
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B2033–4A |
DONGLE NG (Dongle not good) |
Diagnosis condition | Ignition switch ON |
| Signal (terminal) | CAN communication signal | ||
| Threshold | The ID verification results NG | ||
| Diagnosis delay time | 1 second or more | ||
POSSIBLE CAUSE
-
Harness or connector
(The CAN communication line is open or shorted)
-
Intelligent Key unit
-
EPS control unit
FAIL-SAFE
—
CONFIRMATION PROCEDURE
DTC CONFIRMATION
CONSULT
-
Ignition switch ON.
-
Select “Self diagnosis result� mode of “INTELLIGENT KEY�.
Is the DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirm after repair: Inspection End.
DTC Diagnosis Procedure
PERFORM INITIALIZATION
-
Perform initialization of Intelligent Key unit and registration of all Intelligent Keys using CONSULT.
For initialization and registration procedures, refer to CONSULT immobilizer mode and follow the on-screen instructions.
-
Start the engine.
Dose the engine start?
YES>>Inspection End.
NO>>GO TO 2.
REPLACE INTELLIGENT KEY UNIT
Replace Intelligent Key unit. Refer to Removal and Installation.
Is the DTC detected?
YES>>GO TO 3.
NO>>Inspection End.
REPLACE EPS CONTROL UNIT
Replace EPS control unit. Refer to Removal and Installation.
>>
Inspection End.
Other materials:
Trip computer
Basic information
The trip computer switches are located on the left side of the steering wheel, allowing easy access while driving the Nissan Rogue.
Scroll dial – used to move through menu items and select functions within the vehicle information display; it supports up/down navigation and pu ...
Warning and indicator lights
Red light
Brake warning light — alerts the driver to a potential issue with the Nissan Rogue’s braking system or low brake fluid.
Charge warning light — indicates a problem with the charging system or alternator.
Electric shift control system warning light — shows a malfunction r ...
Hvac Branch Line Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the A/C amp. for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal?
Y ...
