Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Warning and indicator lights
Red light
Brake warning light — alerts the driver to a potential issue with the Nissan Rogue’s braking system or low brake fluid.
Charge warning light — indicates a problem with the charging system or alternator.
Electric shift control system warning light — shows a malfunction related to the electric shift control.
Electronic parking brake warning light — notifies the driver of an issue with the parking brake system.
Engine oil pressure warning light — signals low engine oil pressure, requiring immediate attention.
Hands OFF warning light (if so equipped) — alerts the driver to keep hands on the steering wheel while using assist systems.
Master warning light — indicates a general system malfunction requiring the driver’s attention.
Seat belt warning light — reminds occupants to fasten their seat belts.
Supplemental air bag warning light — alerts the driver to a problem with the air bag system.
Yellow light
Anti-lock Braking System (ABS) warning light — indicates an issue with the ABS system.
Automatic Emergency Braking (AEB) system OFF warning light — appears when the AEB system is turned off or unavailable.
Electric power steering warning light — notifies of a malfunction in the electric power steering system.
Electronic parking brake system warning light — indicates an issue with the electronic parking brake.
Front passenger air bag status light — shows whether the front passenger air bag is active or turned off.
Hill descent control system ON indicator light (if so equipped) — appears when hill descent control is active.
Low tire pressure warning light — alerts the driver when tire pressure drops below recommended levels.
Malfunction Indicator Light (MIL) — signals an engine control or emissions-related issue.
Master warning light — appears when the system detects a non-critical but important warning.
Rear Automatic Braking (RAB) system OFF warning light — illuminates when the RAB system is disabled or unavailable.
Slip indicator light — shows that the Vehicle Dynamic Control (VDC) is operating to maintain traction.
Vehicle Dynamic Control (VDC) OFF indicator light — indicates that the VDC system has been manually turned off.
Other light
Automatic brake hold indicator light (white) — shows brake hold is in standby mode.
Automatic brake hold indicator light (green) — indicates active brake hold during stops.
Exterior light indicator — signals that the exterior lights are turned on.
High beam assist indicator light — shows that high beam assist is active.
High beam indicator light — indicates that the high beams are currently engaged.
Turn signal/hazard indicator lights — flash when turn signals or hazard lights are activated.
Other materials:
Intelligent Around View Monitor. Removal and Installation
Around View Monitor Control Unit
Removal and Installation
REMOVALCAUTION:
Perform the “ADDITIONAL SERVICE WHEN REPLACING AROUND VIEW
MONITOR CONTROL UNIT” before replacing around view monitor control
unit. Refer to Description.
Remove the center console assembly. Refer to Removal and Ins ...
Dtc/circuit Diagnosis. Door Lock Actuator
Front Lh
Diagnosis Procedure
CHECK DOOR LOCK ACTUATOR INPUT SIGNAL
Ignition switch OFF.
Disconnect front door lock assembly LH connector.
Check voltage between front door lock assembly LH harness connector and ground.
(+) (–) Condition
Voltage
(Approx.)
Front door lock a ...
Basic Inspection. Configration (intelligent Key Unit)
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the Intelligent Key unit.The
configuration requires network connection. CONSULT connects to network
and then it downloads the configuration data from the server. Then
CONSULT writes th ...
