Nissan Rogue (T33) 2021-Present Service Manual: B24a1-16 A/c Auto Amp. Power Supply

Nissan Rogue (T33) 2021-Present Service Manual / Ventilation, Heater & Air Conditioner :: Heater & Air Conditioning Control System / Manual Air Conditioning :: Dtc/circuit Diagnosis / B24a1-16 A/c Auto Amp. Power Supply

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
B24A1-16

A/C AUTO AMP. POWER SUPPLY

(Air conditioning automatic amplifier power supply) 		Diagnosis condition Ignition switch ON
Signal (Terminal) Accessory power supply
Threshold Open or shorted to ground
Diagnosis delay time 30 seconds or more

POSSIBLE CAUSE

  • A/C amp.

  • Harness or connector (accessory power supply circuits is open or shorted to ground)

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM SELF DIAGNOSIS

CONSULT

  1. Ignition switch ON.

  2. Select "Self diagnosis result" mode of "HVAC".

  3. Check DTC.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK A/C AMP. POWER SUPPLY AND GROUND CIRCUITS

Check A/C amp. power supply and ground circuits. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

Replace A/C amp. Refer to Removal and Installation.

NO>>

Repair or replace malfunctioning parts.

    B24a0-49 A/c Auto Amp.
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24A0-49 A/C AUTO AMP. (Air conditioning automatic amplifier...
    B24a2-55 Configuration Not Implement
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24A2-55 Configuration not implement (Configuration not impl...

    Other materials:

    P10c8 Internal Control Module Fuel Injector
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P10C8 00 Cylinder1 injector A (Cylinder1 injector A) Diagnosis condition — Signal (terminal) — Threshold Injector driver unit is malfu ...

    Basic Inspection. System Setting
    Description The settings of the automatic driving positioner system can be changed, using information display in the combination meter and the set switch. Always check the settings before and after replacing driver seat control unit. For details, refer to Work Procedure.×: ApplicableSetting ...

    Remplacement de la pile de clé intelligente
    AVERTISSEMENT Risque en cas d’ingestion : l’ingestion d’une pile bouton peut entraîner des blessures graves, voire mortelles. Une pile avalée peut provoquer des brûlures chimiques internes en seulement deux heures. Conservez toujours les piles neuves et usagées hors de portée des ...