Nissan Rogue (T33) 2021-Present Service Manual: B2231-16 Battery Voltage
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detected condition | ||
|---|---|---|---|---|
| B2231-16 |
Battery voltage (Battery voltage) |
Diagnosis condition | When ignition switch is ON. | |
| Signal (terminal) | Battery power supply | |||
| Threshold | 8 V or less | |||
| Diagnosis delay time | — | |||
POSSIBLE CAUSE
-
Combination meter
-
Harness or connectors
-
Charging system
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON and wait for 2 seconds or more.
-
Select “Self diagnosis result” mode of “M&A”.
-
Check DTC.
Is DTC B2231-16 detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair:Inspection End.
Diagnosis Procedure
CHECK BATTERY
Check battery. Refer to Work Flow.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace the malfunctioning parts.
CHECK CHARGING SYSTEM
Check charging system condition. Refer to Work Flow (With EXP-800 NI or GR8-1200 NI) or Work Flow (Without EXP-800 NI or GR8-1200 NI).
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning parts.
CHECK COMBINATION METER POWER SUPPLY CIRCUIT
Check combination meter power supply circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>Replace combination meter. Refer to Removal and Installation.
NO>>Repair or replace the malfunctioning parts.
Other materials:
U0469 Can Communication
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
U0469
00
Invalid data (starter/generator C/U)
(Invalid Data Received From Starter / Generator Control Module)
Diagnosis condition
Ignition switch ON
Signa ...
Main Line Between Pwbd and M&a Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side).
Harness connector B41
Harness con ...
Rear View Monitor. Preparation. Preparation
Preparation
Commercial Service Tools
Tool Description
Power tool
Loosening screws
...
