Nissan Rogue (T33) 2021-Present Service Manual: B2267-29 Engine Speed

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detected condition
B2267-29

TACHO METER

(Tacho meter)
Diagnosis condition When ignition switch is ON.
Signal (terminal) Engine speed signal
Threshold ECM continuously transmits abnormal engine speed signals
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

Crankshaft position sensor (POS)

FAIL-SAFE

Reset to zero of the tachometer by suspending communication.

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self diagnosis result” mode of “M&A”.

  3. Check DTC.

Is DTC B2267-29 detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair:Inspection End.

Diagnosis Procedure

PERFORM SELF-DIAGNOSIS OF ECM

CONSULT

Select “Self diagnosis result” mode of “ECM.”

Is DTC detected?

YES>>

Perform diagnosis procedure on the detected DTC. Refer to DTC Index.

NO>>

Inspection End.

    B2231-16 Battery Voltage
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detected condition B2231-16 Battery voltage (Battery voltage) Diagnosis conditio...
    U1321-55 Configuration Unfinished
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1321–55 Config unfinished (Configuration unfinished) Diag...

    Other materials:

    Cylinder Block
    Exploded View CAUTION: Never disassemble or remove components beyond the configuration shown in the figure. Cylinder block Knock sensor Engine oil pressure sensor Engine oil temperature sensor Breather separator assembly gasket Breather separator assembly Rear ...

    Dtc/circuit Diagnosis. Starter Cut Relay
    Component Inspection CHECK STARTER CUT RELAY Ignition switch OFF. Disconnect starter cut relay. Check continuity between starter cut relay terminals. Starter cut relay Condition Continuity Terminal 6 7 12 V direct current supply between terminals 8 and 9 Yes N ...

    Removal and Installation. Rear Deflector
    Exploded View Screw grommet Rear deflector     : Nissan Ariya Vehicle front Removal and Installation REMOVALRemove rear deflector fixing screws and clip, and then remove rear deflector.INSTALLATIONInstallation is in the reverse order of removal. ...