Nissan Rogue (T33) 2021-Present Service Manual: U1321-55 Configuration Unfinished

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Meter, Warning Lamp & Indicator / Type B :: Dtc/circuit Diagnosis / U1321-55 Configuration Unfinished

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
U1321–55

Config unfinished

(Configuration unfinished) 		Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Configuration is incomplete
Diagnosis delay time —

POSSIBLE CAUSE

The configuration for combination meter is not done.

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Ignition switch OFF and wait at least 30 seconds.

  3. Select “Self diagnosis result” mode of “M&A”.

  4. Check DTC.

Is DTC "U1321-55" detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair:Inspection End.

Diagnosis Procedure

PERFORM CONFIGURATION OF COMBINATION METER

CONSULT

Perform configuration of combination meter. Refer to Description.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

Perform DTC confirmation procedure again. Refer to DTC Description.

Is DTC "U1321-55" detected?

YES>>

Replace combination meter. Refer to Removal and Installation.

NO>>

Inspection End.

    B2267-29 Engine Speed
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detected condition B2267-29 TACHO METER (Tacho meter) Diagnosis condition When i...
    U2118-87 Can Comm Circuit
    DTC Description CAN (Controller Area Network) is a serial communication system for real time application. It is an on-Nissan Ariya vehicle multiplex communication system with hi...

    Other materials:

    Kr15ddt. Service Data and Specifications (sds). Service Data and Specifications (sds)
    Service Data and Specifications (sds) A/C compressor Model DENSO make 6SAS14C Type Variable displacement swash plate Displacement cm3 (cu in)/rev Maximum 140 (8.6) Direction of rotation Clockwise (viewed from clutch) Drive belt Poly V Lubricant Na ...

    Removal and Installation. Terminal Plate
    Exploded View 1. Terminal plate cover 2. Terminal plate 3. Terminal plate bracket A. Harness (rear) B. Harness (center) C. Harness (front) : Pawl         Removal and Installation REMOVALDisconnect the 12V battery negative a ...

    2wd. Preparation. Preparation
    Preparation Commercial Service Tools Tool name Description Ball joint remover Removing hub bolt Always Replace with New Parts Never Reuse These Parts Part CodeFor additional information Bush - Radius, Axle 43052H Exploded View Bush - LWR Link, FR Axle 43052D E ...