Nissan Rogue (T33) 2021-Present Service Manual: B Terminal Circuit
Diagnosis Procedure
CHECK “B” TERMINAL CONNECTION
-
Ignition switch OFF.
-
Check if “B” terminal is clean and tight.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair “B” terminal connection.
CHECK “B” TERMINAL CIRCUIT
Check voltage between generator “B” terminal and ground.
| (+) | (-) | Voltage (Approx.) | |
|---|---|---|---|
| Generator | |||
| Connector | Terminal | ||
| F125 (without ProPILOT Assist 2.1) | 7 | Ground | Battery voltage |
| F129 (with ProPILOT Assist 2.1) | 7 | Ground | Battery voltage |
Is the inspection result normal?
YES>>GO TO 3.
NO>>Check harness for open between generator and fusible link.
CHECK “B” TERMINAL CONNECTION (VOLTAGE DROP TEST)
-
Start engine, then engine running at idle and warm.
-
Check voltage between 12V battery positive terminal and generator “B” terminal.
(+) (-) Voltage (Approx.) Generator Connector Terminal 12V battery positive terminal F125 (without ProPILOT Assist 2.1) 7 Less than 0.2 V 12V battery positive terminal F129 (with ProPILOT Assist 2.1) 7 Less than 0.2 V
Is the inspection result normal?
YES>>“B” terminal circuit is normal. Refer to Work Flow (With EXP-800 NI or GR8-1200 NI) or Work Flow (Without EXP-800 NI or GR8-1200 NI).
NO>>Check harness between 12V battery and generator for poor continuity.
Other materials:
Ecu Diagnosis Information. Driver Seat Control Unit
Values on the Diagnosis Tool
NOTE:
The following table includes information (items)
inapplicable to this Nissan Ariya vehicle: For information (items)
applicable to this vehicle, refer to CONSULT display items.
Monitor Item Condition Value/Status
Memory switch 1
Memory switch-1
Pr ...
Radio Antenna
The antenna on the Nissan Rogue is located on the rear part of the vehicle roof and is designed to provide stable radio reception during everyday driving.
CAUTION
A build-up of ice on the antenna can affect radio performance.
Remove the ice to restore proper radio reception on your Nissan Rogue.
...
Exhaust Gas Temperature Sensor
Component Inspection
CHECK EXHAUST GAS TEMPERATURE SENSOR
Turn ignition switch OFF.
Disconnect exhaust gas temperature sensor harness connector.
Check resistance between exhaust gas temperature sensor connector terminals.
Exhaust gas temperature sensor Resistance (kΩ)
Connecto ...
