Nissan Rogue (T33) 2021-Present Service Manual: Awd :: Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting

Nissan Rogue (T33) 2021-Present Service Manual / Transmission & Driveline :: Rear Axle / Awd :: Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting

Noise, Vibration and Harshness (nvh) Troubleshooting

NVH Troubleshooting Chart

Use chart below you find the cause of the symptom. If necessary, repair or replace these parts.

Possible cause and SUSPECTED PARTS Symptom Reference
DRIVE SHAFT REAR AXLE
Noise Shake Noise Shake Vibration Shimmy Judder Poor quality ride or
Excessive joint angle × × — — — — — — —
Joint sliding resistance × — — — — — — — Inspection
Imbalance — × — — — — — — — 
Improper installation, looseness — — × × × × × × Exploded View
Parts interference — — × × × × — × —
Propeller shaft × × × × × — — — NVH Troubleshooting Chart
Differential × — × — — — — — NVH Troubleshooting Chart
Rear axle and rear suspension × × × × × × × ×

  • Refer to REAR AXLE in this chart

  • REAR SUSPENSION: NVH Troubleshooting Chart
Rear axle × × — — — — — — Refer to REAR AXLE in this chart
Tire × × × × × × × × NVH Troubleshooting Chart
Road wheel × × × × — × × × NVH Troubleshooting Chart
Drive shaft — — × × × — — — Refer to DRIVE SHAFT in this chart
Brake × × × × — × × — NVH Troubleshooting Chart

×: Applicable, —: Not applicable

    Awd. Preparation. Preparation
    Preparation Special Service Tool Tool number Tool name Description KV40104000 Hub lock nut wrench a: 85 mm (3.35 in) b: 65 mm (2.56 in) Removing and Installing wheel hub lock nu...
    Awd. Periodic Maintenance
    Rear Wheel Hub and Housing Inspection COMPONENT PARTMake sure that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are no...

    Other materials:

    P0500 Vss
    DTC Description DESCRIPTIONECM receives vehicle speed signals from two different paths via CAN communication line: One is from the ABS actuator and electric unit (control unit) via the combination unit and the other is from TCM.DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagno ...

    P26a3 Multi-Way Control Valve Motor
    DTC Description DTC DETECTION LOGICNOTE: If DTC P26A3 is displayed with DTC P26A5, P26A6, and/or P26A7 first perform the trouble diagnosis for DTC P26A5, P26A6, and/or P26A7. Refer to DTC Index. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P26A3 00 ...

    Evap Control System Pressure Sensor
    Component Inspection CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR Turn ignition switch OFF. Remove EVAP control system pressure sensor with its harness connector connected from EVAP canister. Always replace O-ring with a new one. Install a vacuum pump to EVAP control system pressure se ...