Nissan Rogue (T33) 2021-Present Service Manual: Awd :: Periodic Maintenance

Nissan Rogue (T33) 2021-Present Service Manual / Transmission & Driveline :: Rear Axle / Awd :: Periodic Maintenance

Rear Wheel Hub and Housing

Inspection

COMPONENT PART

Make sure that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.

WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)

Check the following items, and replace the part if necessary.

  • Move wheel hub and bearing assembly in the axial direction by hand. Check there is no looseness of wheel bearing.

    Axial end play : Refer to Wheel Bearing.

  • Rotate wheel hub and make sure there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub and bearing assembly.

Rear Drive Shaft

Inspection

REAR DRIVE SHAFT INSPECTION

Check the following items, and replace the part if necessary.

  • Check drive shaft mounting point and joint for looseness and other damage.

    CAUTION:

    Replace entire drive shaft assembly when noise or vibration occur from drive shaft.

  • Check boot for cracks and other damage.

    Awd. Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
    Noise, Vibration and Harshness (nvh) Troubleshooting NVH Troubleshooting Chart Use chart below you find the cause of the symptom. If necessary, repair or replace these parts. Po...
    Awd. Removal and Installation
    Rear Wheel Hub and Housing Exploded View JAPAN PRODUCTION MODELS Axle housing Bushing Hub cap Back plate Hub bolt Wheel hub and bearing assembly Disc rotor Wheel hub lock nut Co...

    Other materials:

    Hd Map (hd Map Module)
    B14a0-45 Control Module DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms DTC detection condition   B14A0 45 Control module 1 Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Internal error Diagnosis delay ti ...

    Symptom Diagnosis. Anti-Pinch Function Does Not Operate
    Moonroof System Diagnosis Procedure PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to Description. Is the inspection result normal? YES>> Inspection End. NO>> Replace moonroof motor assembly. Refer to Removal and Installation. Sunshade Diagnosis Proce ...

    B Terminal Circuit
    Diagnosis Procedure CHECK “B” TERMINAL CONNECTION Ignition switch OFF. Check if “B” terminal is clean and tight. Is the inspection result normal? YES>> GO TO 2. NO>> Repair “B” terminal connection. CHECK “B” TERMINAL CIRCUIT Check voltage between g ...