Nissan Rogue (T33) 2021-Present Service Manual: Adjustment of Brake Caliper Initial Position

Nissan Rogue (T33) 2021-Present Service Manual / Brakes :: Brake Control System / With Vdc :: Basic Inspection / Adjustment of Brake Caliper Initial Position

Description

CAUTION:

When performing the following operations, always use CONSULT (It cannot be performed by any means other than CONSULT.), for performing "INITIALIZATION POSITION ADJUSTMENT" of "WORK SUPPORT". Refer to Work Procedure.

×: Required —: not required

Procedure INITIALIZATION POSITION ADJUSTMENT
Removing/ installing ABS actuator and electric unit (control unit) —
Replacing ABS actuator and electric unit (control unit) ×
Removing/ installing rear brake pad (When not pressing piston of rear brake caliper assembly) —
Removing/ installing rear brake pad (When pressing piston of rear brake caliper assembly) —
Replacing rear brake pad ×
Removing/ installing rear brake caliper assembly —
Replacing rear brake caliper assembly ×
Removing/ installing parking brake switch —
Replacing parking brake switch —

Work Procedure

PERFORM INITIALIZATION POSITION ADJUSTMENT

  1. Select "ABS", "Work support", and "INITIALIZATION POSITION ADJUSTMENT" according to this order.

    CAUTION:

    • Never operate the parking brake switch.

    • Never depress the brake pedal.

  2. Touch "START".

>>

GO TO 2.

PERFORM THE SELF-DIAGNOSIS

CONSULT

  1. Ignition switch OFF (Auto ACC function OFF) to ON.

  2. Erase self-diagnosis results memory of "ABS".

  3. Pull parking brake switch to activate electric parking brake.

  4. Push parking brake switch to release electric parking brake.

  5. Perform self-diagnosis for “ABS”.

Is malfunction detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

Inspection End

    Calibration of Decel G Sensor
    Description CAUTION: Always perform the decel G sensor calibration before driving when the following operation is performed. Refer to Work Procedure. ×: Required —: Not requi...
    Removal/replacement of Rear Brake Pad or Rear Brake Caliper
    Description CAUTION: When performing the following operations, always use CONSULT, for performing “START BRAKE PAD REPLACEMENT”, “FINISH BRAKE PAD REPLACEMENT”, “INITI...

    Other materials:

    C1f03-23 Operation Sw Circ
    Without Propilot Assist 2.1 DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition   C1F03 23 OPERATION SW CIRC (Operation switch circuit) Diagnosis condition When engine is running When ProPILOT Assis ...

    Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
    NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference REAR SUSPENSION Noise Shake Vibration Shimmy Judder Poor quality ride or handling Improper installation, loos ...

    Removal and Installation. Steering Gear and Linkage
    Exploded View 1. Outer socket 2. Boot clamp (small diameter) 3. Boot 4. Boot clamp (large diameter) 5. Hole cover seal A. Outer socket lock nut. B. Inner socket lock nut. — — — — CAUTION: Never apply the grease to the surface be ...