Nissan Rogue (T33) 2021-Present Service Manual: U2384 Can Comm Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / U2384 Can Comm Circuit

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
U2384 83

CAN comm err (eVTC)

[CAN comm err (eVTC)] 		Diagnosis condition Ignition switch ON
Signal (terminal) CAN communication signal
87 Threshold ECM is not receiving CAN communication signal other than OBD (emission related diagnosis).
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Harness or connectors (CAN communication line is open or shorted)

  • Electric intake valve timing control module

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC U2384 is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?

YES>>

Proceed to DTC Description.

NO>>

GO TO 2.

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON and wait at least 3 seconds.

  2. Check 1st trip DTC.

Is DTC U2384 detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK DTC PRIORITY

If DTC U2384 is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?

YES>>

Proceed to DTC Description.

NO>>

Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

    U2276 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2276 83 CAN comm err (CCM) [CAN comm err (CCM)] Diagnosis condi...
    U2385 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2385 87 CAN comm err (VCR) [CAN comm err (VCR)] Diagnosis c...

    Other materials:

    With Vdc. Preparation. Preparation
    Preparation Special Service Tool The actual shapes of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description KV991J0080 (NI-45741-A) ABS active wheel sensor tester Checking operation of wheel sensors ...

    Parameter Writing
    Work Procedure DescriptionWhen replace each camera, it is necessary to write the camera parameters using CONSULT.Write to around view monitor control unit according to "Parameter writing" procedure of "CONSULT Operation Manual".Work ProcedurePARAMETER WRITING CONSULT Power switch ON. Sel ...

    Symptom Diagnosis. Driver Side Power Window Does Not Operate
    Diagnosis Procedure CHECK POWER WINDOW MAIN SWITCH POWER SUPPLY AND GROUND CIRCUIT Check power window main switch power supply and ground circuit. Refer to Diagnosis Procedure. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. CHE ...